Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note: Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
Position the machine on a level surface, stop the engine,
and engage parking brake.
Raise the booms into the transport position and remove
the ignition key.
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition switch before
you do any maintenance.
Description
No parts required
No parts required
Bracket
Bumper
Bolt (5/8 x 5 inches)
Nut (5/8 inch)
Bolt (5/16 x 1 inch)
Nut (5/16 inch)
Decal 114-9576
No parts required
Qty.
–
Prepare the machine.
–
Drill the boom.
2
2
2
2
Install the stops.
8
8
2
–
Adjust the booms to level.
2
Use
Advertisement
