Advertisement
Mast Clamp
L-Bracket
(Shown for Down-Tilt Mounting)
Mounting
This antenna can be mounted in an up or down tilt
position based on how the L-Bracket is attached
to the mast. The above photo shows the correct
orientation for down-tilt mounting (for up-tilt, rotate
L-Bracket 180 degrees).
Attach the L-Bracket to mast using supplied U-Bolt
and hardware. This mounting kit can be used with
masts 1.25" (32mm) to 2.12" (54mm) O.D.
IP-00125 Rev. A – 07/12 Page 2/2
U-Bolt
Drain Hole
Locations
L-com Global Connectivity | 50 High St., West Mill, 3rd floor, Suite #30 | North Andover, MA 01845 | USA
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com Logo are registered marks.
Toll Free Ordering and Technical Support: 1-800-343-1455
INSTALLATION INSTRUCTIONS: HG8909P
Orientation Label
Vertical or Horizontal Polarized Mounting
This antenna can be vertical polarized or horizontal polarized
mounted. To mount antenna, attach to L-Bracket as shown
using supplied hardware. Note orientation label on rear of antenna
for proper mounting.
To help prevent moisture build-up inside the antenna, drain holes
are provided. To ensure proper draining, these holes must be
orientated on the bottom of the antenna as shown.
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
www.L-com.com
Advertisement
