Defender OT01287 Manual

MAX ULTRA SOLAR SECURITY LIGHT
Ultra Powered PIR Security Light
Introduction
The Defender Max Ultra Solar Security Light is a solar powered light with an extremely bright 1200
lumen output. The light is extremely bright, with 150 super bright white LEDs. The unit is easy to
install and comes with 4.7m of cable to attach the solar panel to the light unit.
The unit has a manual On-Off-Auto switch which allows the user to keep the light on
constantly, off or on automatic, which uses the PIR to automatically switch on the light when
somebody walks past.
Contents
1 x Solar Light
1 x Solar Panel (with 4.7m cable)
1 x Mounting Bracket
8 x Wall Plugs
8 x Screws
Caution
• Do not install the light close to people or cars. Keep out of reach of children.
• Do not install the unit close to flammable items.
• Do not stare directly into the light.
Charging the Battery
To charge the unit, connect the solar panel to the light unit using the attached cable ensuring the
solar panel jack is fully inserted into the socket in the light unit. Ensure the solar panel is facing the
sun and wipe the panel regularly as dirt can affect the battery efficiency.
Installation
The Defender Max Ultra Solar Security Light comes with a 4.7m cable to connect the light unit and
the solar panel, allowing the two units to be 4.7m apart. Decide on the location of the light,
ensuring the solar panel is in a location that receives full, direct sun for a minimum of 8 hours a
day. Mount the light unit 2-3 meters above the ground on a solid surface capable of supporting
the light even in windy conditions. The unit must be installed high enough to provide effective
motion detection and light distribution.
Use the mounting bracket provided as a template, mark the holes that need to be drilled,
ensuring there are no cables or electrical lines behind the wall. Drill the holes and install the wall
plugs. Place the mounting bracket back over the holes and thread the enclosed screws to secure
the bracket in position. Do the same for the solar panel unit. When both units are mounted on
the wall, carefully install the Defender Max Ultra to the bracket and attach the power cord to the
light. Adjust the motion detector head below the light by moving it left or right so that it faces the
desired area. Move it up or down by turning the dial located on the neck of the motion detector
head. Tighten the dial when the desired position has been reached.
defendersecurityproducts.co.uk
Product Code: OT01287