Advertisement
I N S TA L L AT I O N A N D O P E R AT I N G I N S T R U C T I O N S
Wiring
Connect wires per wiring diagram below according to application. Do not mate battery connector until all wiring is complete and power is
restored. Wiring diagram for typical application that shares the fixture's LED load is seen below. For alternate application wiring diagrams see
Hatch website at www.hatchlighting.com/led-emergency-drivers.
NOTE: Emergency driver housing must be grounded.
Wall Switch
L
(Black)
N
(White)
Normal Mode: AC power is present. The AC driver operates the LED load as designed. The emergency pack is charging in a standby mode.
The test button will be illuminated red, showing that AC power is present.
Emergency Mode: In the event of a power failure, the LED emergency driver switches to emergency mode and operates the fixture at the
rated emergency driver output power level for a minimum of 90 minutes.
Testing Procedures
Prior to initial testing, allow unit to charge one hour. For 90 minute test, allow unit to charge for 24 hours.
a. Press the test button to disconnect the power to the AC driver and switch the system to Emergency Mode. Release the test button to
return to Normal Mode. Switch off the circuit breaker to simulate a full power outage.
b. NFPA 101, Life Safety Code outlines the following testing schedule:
i. Monthly: Ensure that the test button light is illuminated. Conduct a 30 second discharge test by depressing the test button for 30
seconds. The LED load should operate at reduced output.
ii. Annually: Ensure that the test button is illuminated. Conduct a full 90-minute discharge test. The unit should operate as intended
for the duration of the test.
iii. Written records of the testing shall be kept by the owner for inspection by the authority having jurisdiction.
Luminaire Modification Label
Make sure to adhere luminaire modification label to the fixture where it is easily visible to anyone servicing the fixture in the future.
3
WWW.HATCHLIGHTING.COM • 7821 W
E M E R G E N C Y L E D D R I V E R :
L
(Black)
LED Driver
N
(White)
LED Emergency
(Black/White)
Driver
(Red AWG#22)
(Blue AWG#22)
(Grey AWG#22)
Test
Switch/Charge
Indicator
ELP05‐UNV‐K, ELP12‐UNV‐K
WIRING DIAGRAM - TYPICAL APPLICATION
SHARED FIXTURE LOAD
®
C
B
. T
OOdLANd
eNTer
Lvd
AMpA
LED +
(Red)
LED ‐
(Black)
(Brown)
+
(Red AWG#18)
‐
(Blue AWG#18)
Battery
Connector
OPERATION
, FL 33614 • pH: 813.288.8006 • FX: 813.288.8105 • S
Fixture LED
Load
@
.
r
: 07/14/2021
ALeS
HATCHLIGHTING
COM
ev
Advertisement
