Advertisement
Usage:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into
a circuit that is servicing other electrical needs.
Control Panel
On/Speed
Controls
Off
Control
On/Off Speed Control
Turning Fan On/Off:
Place fan on stable level surface.
Plug fan into properly grounded outlet. To start the fan, press
desired speed button: 1-LOW, 2-MED, 3-HIGH. Press 0-OFF to
discontinue use. Unplug fan when not in use.
Oscillation:
To start fan oscillation, press Oscillation Control
Knob (located above motor housing) down.
To stop oscillation function pull Oscillation Control Knob up while
the fan is in any oscillation position.
Fan Assembly:
Simple assembly is required.
Step 1
Unfold patented
Quad-Pod
base legs.
®
Step 3
Pull
Chrome
Extension
Out
With collar nut loosened,
pull Chrome Extension out
of Fan Pedestal.
Oscillation Control
Oscillation Control Knob
Step 2
Place decorative Plastic Flange
over Extension Pole to cover
the base. Slide pedestal pole
into base receptacle. Tighten
nut to secure in place. Slide
flange over base connection.
Step 4
Step 5
Thumb
Screw
Remove the Blade Cap by
Assemble fan Control
twisting it CLOCKWISE while
Panel/Motor assembly
holding the metal shaft tightly.
onto Chrome Extension
Note: Th reads a re reversed.
and tighten thumbscrew.
Unscrew = Clockwise.
Step 6
Pin
Pin
Assemble Rear Grille onto
Motor Housing. Rear Grille
should fit into pins on fan
motor housing as shown.
Step 8
Pin
Slot
Remove any protective
covering over shaft before Fan
Blade Installation. Place Fan
Blade onto Motor Shaft. Notice
the pin on Motor Shaft should
fit into slots of Fan Blade.
Step 10
With logo upright, attach
Front Grille to Rear Grille by
snapping them together. Be
sure all 8 clips are secure.
Step 7
Lock-Nut
Thread Locknut onto Motor
Housing to lock Rear Grille
in place.
Step 9
Thread Blade Cap onto
threaded end of Motor Shaft.
Note: Th reads are reversed.
Tighten = Counte r-clockwise.
3
3
Advertisement
