Samsung DE6612-D Service Manual page 7

2. Microwave Oven Installation Requirements (continued)
Installation(Continued)
To make a hole in an accurate location, create a mark in advance with a hammer and punch. Smooth any rough
edges on the holes and apply rust proof treatment to them.
Remove one screws securing outer panel of microwave oven(right side)
Attach left and right brackets to the outer panel panel using 8 screws(Fig.1)
Secure the microwave oven brackets to the frame which has drilled holes( 4.0~4.2) using 6 screws
(Tap Screws).(Fig.2)
Fig.3 shows how the microwave should look attached to the frame.
If the electrical wiring does not work after the oven is fastened tightly, first follow the "electrical Wiring (Page
7-8)" instructions and then re-fasten the oven.
The oven must be fastened tightly to protect against vibration.
If do not want to use brackets, please attach 8screws(#4x12) on left and right side of the outer panel directly(Fig.4)
. When you do not want to use brackets(Left/Right), the
installations using the base plate of microwave oven are
Á
as follows :
Attach left and right side to the outer panel using
Â
8 screws.(Fig.4)
Remove 4 plastic screws on the base plate of microwave
Ã
oven.(Fig.5)
Attach 4 M8 screws (machine screw) tightly to the position of
foot hole on the base plate through the frame.
Á
PRECAUTION
.The length of 10-15mm must be maintained in inserting 4
M8 screws in the foot holes of base plate.
If 4 M8 screws is inserted into holes under 10mm, the
microwave oven become weak in the vibration of a vehicle.
If 4 M8 screws is inserted into holes over 15mm, it can
induce a defeat or a damage in the microwave oven as
screws is close to the electrical object.
fig.5
4 Screws
(Plastic Screws)
- 6 -
Base Plate