SBS Technologies PMC-GIGABIT-DT2 User Manual

Pmc with dual 10baset/100basetx/1000baset gigabit ethernet interfaces

Advertisement

Quick Links

sales@artisantg.com
artisantg.com
(217) 352-9330 |
|
Click HERE
Find the Abaco Systems / SBS PMC-Gigabit-DT2 at our website:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PMC-GIGABIT-DT2 and is the answer not in the manual?

Questions and answers

Summary of Contents for SBS Technologies PMC-GIGABIT-DT2

  • Page 1 (217) 352-9330 | Click HERE Find the Abaco Systems / SBS PMC-Gigabit-DT2 at our website:...
  • Page 2 PMC-GIGABIT-DT2 PMC with Dual 10BaseT/100BaseTX/1000BaseT Gigabit Ethernet Interfaces User Manual ©SBS Technologies, Inc. Subject to change without notice. Hardware Revision: A Part No. 89004530 Rev. 2.2 20060502 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
  • Page 3 IndustryPack is a registered trademark of SBS PMC with Technologies, Inc. QuickPack, SDpacK and Unilin are trademarks SBS Technologies, Inc. PC•MIP is Dual 10BaseT/ a trademark of SBS Technologies, Inc. and MEN 100BaseTX/ Mikro GmbH. 1000BaseT Gigabit Ethernet Interfaces SBS Technologies, Inc acknowledges the trademarks of other organizations for their SBS Technologies, Inc.
  • Page 4: Table Of Contents

    Table of Contents PRODUCT INFORMATION _______________________________________________ 1 ________________________________________________________ 1 EATURES BLOCK DIAGRAM______________________________________________________ 2 PROGRAMMING _______________________________________________________ 3 PMC/PCI(-X) I ________________________________________________ 3 NTERFACE MAC A ______________________________________________________ 4 DDRESSES MII M _____________________________________________ 5 ANAGEMENT NTERFACE CONNECTORS AND INDICATORS ________________________________________ 6 RJ45 P _______________________________________ 7 RONT ANEL SSIGNMENT...
  • Page 5 2. PCI C 82546EB ____________ 3 IGURE ONFIGURATION EGISTERS FOR UNCTION 3. PCI C 82546EB ____________ 4 IGURE ONFIGURATION EGISTERS FOR UNCTION 3. PMC-GIGABIT-DT2 P ___________________________ 6 IGURE LACEMENT IAGRAM 4. PMC-GIGABIT-DT2 F __________________________ 6 IGURE RONT ANEL IAGRAM 5. F...
  • Page 6: Product Information

    1000BaseT over category 5 twisted pair cable. Full and half duplex modes are supported. The PMC-GIGABIT-DT2 uses the Intel 82546EB that includes 64 Kbytes FIFO buffer memory, allowing back-to-back transmissions with minimum interface latency. It also features a 10BaseT, 100BaseTX and 1000BaseT auto-detection CSMA/CD interface controller.
  • Page 7: Block Diagram

    Block Diagram 3.3V Voltage Conversion PORT 1 2.5V 1.5V MDI[3:0]+/- MAGNETICS RJ45 PCI/PCI-X 82546EB MAC/PHY MDI[3:0]+/- MAGNETICS RJ45 PORT 2 Serial Clock EEPROM 25 MHz Figure 1. Block Diagram Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
  • Page 8: Programming

    1.0a specifications. It is a multifunction device, with two Ethernet ports that appear as two separate functions to the host. Each function has its own register sets. The PMC-GIGABIT-DT2 is mapped into PCI memory space. In addition to PCI Configuration Registers, it implements configuration registers that are specific to PCI-X.
  • Page 9: Mac Addresses

    Gigabit Ethernet Controller. Consult the 82546EB Gigabit Ethernet Controller Specification Update for the latest stepping information. In a PCI-X system, the PMC-GIGABIT-DT2 can be configured in different PCI(-X) mode depending on the resistor value of R62 that connects to PMC P1 connector pin 39:...
  • Page 10: Mii Management Interface

    MII Management Interface 82546EB provides software access to the MII management registers in the PHY via MDIC registers. There are two MDIC registers, one for each port. Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
  • Page 11: Connectors And Indicators

    Connectors and Indicators Figure 3. PMC-GIGABIT-DT2 Placement Diagram Figure 4. PMC-GIGABIT-DT2 Front Panel Diagram Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
  • Page 12: Front Panel Rj45 Pin Assignment

    Front Panel RJ45 Pin Assignment There are two RJ45 connectors, one for each port. The RJ45 connector pin assignments are shown below. Note that the 1000BT uses all four pairs at the same time and that each pair can send and receive signals simultaneously. In addition, the controller chip automatically swaps the pairs if necessary.
  • Page 13: Pmc P1 Connector Pin Assignment

    PMC P1 Connector Pin Assignment Signal Signal Name Number Name Number -12V 2 (BP) Ground INTA# INTB# INTC# 6 (N/C) BUSMODEl# 8 (BP) 9 (N/C) INTD# PCI-RSVD 10 (N/C) Ground PCI-RSVD 12 (N/C) Ground Ground GNT# REQ# 18 (BP) V (I/O) AD[31] AD[28] AD [27]...
  • Page 14: Pmc P2 Connector Pin Assignment

    PMC P2 Connector Pin Assignment Signal Name Signal Name Number Number +12V TRST# Ground Ground PCI-RSVD 8 (N/C) 9 (N/C) PCI-RSVD PCI-RSVD 10 (N/C) 11 (N/C) BUSMODE2# +3.3V RST# BUSMODE3# 3.3V BUSMODE4# PME# Ground AD[30], AD[29] Ground AD[26] AD[24] +3.3V IDSEL AD[23] +3.3V...
  • Page 15: Pmc P3 Connector Pin Assignment

    PMC P3 Connector Pin Assignment Signal Name Signal Name Number Number 1 (N/C) PMC-RSVD Ground Ground C/BE[7]# C/BE[6]# C/BE[5]# C/BE[4]# Ground V (I/O) PAR 64 AD[63] AD[62] AD[61] Ground Ground AD[60] AD[59] AD[58] AD[57], Ground V (I/O) AD[56] AD[55] AD[54] AD[53], Ground Ground...
  • Page 16: Specifications

    Specifications PCI Interface 66/133 MHz PCI-X bus PCI-X 1.0 specification 33/66 MHz, 32/64-bit, master and slave, 3.3/5V signaling PCI Protocol and Electrical Rev. 2.2 PMC Conformance 64-bit PMC Specification IEEE P1386.1 PCI Controller / Ethernet MAC Intel 82546EB Number of Ports Protocols Ethernet 10BaseT, 100BaseTX and 1000BaseT Receive/Transmit FIFOs...
  • Page 17: Repair

    For service of SBS Technologies, Inc. products not purchased directly from SBS Technologies, Inc., contact your reseller. Products returned to SBS Technologies, Inc. for repair by other than the original customer will be treated as out-of-warranty.

Table of Contents