Download Print this page
DAVIS 6616 User Manual

DAVIS 6616 User Manual

Extra solar panel kit

Advertisement

Quick Links

USER
MANUAL
Extra Solar
Panel Kit
Product Number 6616
Davis Instruments, 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A. • 510-732-9229 • www.davisnet.com
R

Advertisement

loading

Summary of Contents for DAVIS 6616

  • Page 1 USER MANUAL Extra Solar ™ ™ Panel Kit Product Number 6616 Davis Instruments, 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A. • 510-732-9229 • www.davisnet.com...
  • Page 2: Contents Of Package

    The kit’s weather-resistant shelter has been carefully designed to allow for the mounting of all Davis weather station consoles and Envoys. It can also be used to supply extra power to Vantage Connect. The weather resistant housing can also be used to house batteries or other field equipment.
  • Page 3 Tools for Setup • Adjustable wrench or 7/16 wrench • Drill and 3/16 (5 mm) drill bit (if mounting on a vertical surface) • Phillips head screwdriver Using the Extra Solar Panel Kit with a Solar Power Kit or Vantage Connect In low light conditions, you may use an Extra Solar Panel Kit to provide additional solar charging to your Vantage Connect battery or Solar Power Kit battery.
  • Page 4 3. From inside the shelter, feed the single-connector end of the Y-cable down through the hole in the floor of the shelter. Outside the shelter, wrap a round- hole grommet around the cable and insert the grommet snuggly into the hole. Feed cable down through hole Y-Cable...
  • Page 5: Mounting The Shelter

    Installing a console or Envoy in the shelter For convenience, you can mount any Davis console or Envoy inside the Extra Solar Panel shelter using the included 1/2'' pan head screws. Inside the shelter, outlines of the Vantage Pro2 console, Vantage Vue console, and Envoy and marked mounting holes will indicate where to mount your console or Envoy in the shelter.
  • Page 6 through the two holes at the top of the shelter. 2. Place a mounting plate over the bolt ends, then place lock washer and a hex nut on each of the bolt ends. 3. Tighten the nuts using an adjustable wrench or 7/16'' wrench. 4.
  • Page 7: Contacting Davis Technical Support

    , and Weather Envoy trademarks of Davis Instruments Corp., Hayward, CA. © Davis Instruments Corp. 2012. All rights reserved. Information in this document subject to change without notice. Davis Instruments Quality Management System is ISO 9001 certified. ® 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A.