Advertisement
OPERATION
Each arm of the Light Up Spinner contains an LED light.
You can activate the LED light in one, two, or all three arms.
The lights will turn off automatically after 10 minutes.
To activate the LED lights:
1. Press the switch on the LED casing to activate the
LED lights in fast-flash mode. The three color lights will
alternately flash in this mode.
2. Press the switch again to change the LED lights to
slow-flash mode.
3. Press the switch a third time to activate fast-flash mode
without the alternate flashing feature.
4. Press the switch a fourth time to turn off the LED lights.
There will be a slight delay before the lights turn off.
CHANGING THE BATTERIES
The Light Up Spinner includes three replaceable CR1220
batteries. To replace the batteries:
1. Push on the back (the side that does not have the
2
switch) of the LED casing to remove it from the arm.
Note that the casing fits tightly in the arm. When you
apply sufficient pressure, the casing will pop out. Ensure
that the casing lands on a soft surface.
2. Pry open the LED casing and remove the LED module.
3. Using a fingernail or thin tool, slide the battery out of the
back of the LED module.
4. Insert a new CR1220 battery, with the positive side (the
side imprinted with the battery name) facing up.
5. Place the LED module into the LED casing, with the
battery facing the back of the LED casing (the side that
does not have the switch) and close the LED casing.
6. Place the LED casing back into the arm, pushing with
sufficient force to snap into place. Ensure that all three
LED casings are inserted in the same orientation.
SPECIFICATIONS
Batteries ...................................................CR1220 Lithium Cell, 3V (3)
Dimensions ..................................................2.95 in. x 2.95 in. x 0.47 in.
3
Advertisement
