Page 1
BMID I Installation Manual Battery Management Tool BMID I Rev Feb 2023 These commodities, technology, or software were exported from the United States in accordance with the Export Administration Regulations. Diversion contrary to US law prohibited.
Page 2
Webasto's installation network. This manual shall not be disclosed in whole or in part to any other party without Webasto’s prior written permission. Each recipient's acceptance of this manual and use of the information contained herein shall be deemed to be an acceptance of this non-disclosure obligation.
4.2 Single Schaltbau Euro Connector Communication Wiring, Battery Side ......11 4.3 Dual SBX Connector Communicating Wiring, Charger and Battery Side ....... 12 4.4 Dual Anderson Euro Connector Communication Wiring, Battery Side …………………..12 5912853 A01 3 of 12 Webasto Charging Systems, Inc.
This manual describes the installation of the Battery Monitor and ID module (BMID) on a battery compatible with a Webasto PosiCharge charger. The BMID is located on the forklift battery pack to monitor the condition of the pack and to communicate the type of battery to the charger.
Also, select a location CAUTION it will not be damaged during normal operation or maintenance. Route the voltage sensing lines to the positive (red wire) and the negative (black wire) terminals of the battery. 5912853 A01 5 of 12 Webasto Charging Systems, Inc.
Use the same procedure as above except install the brass insert in the center of the terminal bolt head. After applying the grease, snap the caps onto the bolt head to insulate the connection. Figure 3 – Bolted Battery Installation 5912853 A01 6 of 12 Webasto Charging Systems, Inc.
Page 7
Voltage sense BMID Data Connector wire, red, "+" BMID Data and Direction Wires BMID, Temp. Sensor secured to pack Figure 4 - Typical BMID Installation on a Single Connector Battery Pack 5912853 A01 7 of 12 Webasto Charging Systems, Inc.
Page 8
Data wire connector (4 wire) SBX Connector, Yellow Battery Patch Cable Assemblies See document #09441-76 Battery Modification Instructions SBX Connector, Blue Figure 5 - Typical BMID Installation on a Dual SBX Battery Pack 5912853 A01 8 of 12 Webasto Charging Systems, Inc.
4. Enter the secondary key code (Up Arrow and Down Arrow for 10 seconds). There will be no indication that the key code has been accepted. 5. Press the Select button until Initialize BMID is displayed, the press the Enter button. 5912853 A01 9 of 12 Webasto Charging Systems, Inc.
Page 10
10. Enter the remaining BMID parameters. NOTE: The BMID S/N is not editable. The Initialize Date parameter is automatically set to the date configured in the charger and is not editable. 5912853 A01 10 of 12 Webasto Charging Systems, Inc.
Figure 6 - Wiring for Anderson Euro A32 4.2 Single Schaltbau Euro Connector Communication Wiring, Battery Side Figure 7 - Wiring for Schaltbau Euro LV320 5912853 A01 11 of 12 Webasto Charging Systems, Inc.
4.3 Dual SBX Connector Communicating Wiring, Charger and Battery Side Figure 8 – Wiring for Dual SBX 320 Connector 4.4 Dual Anderson Euro Connector Communication Wiring, Battery Side Figure 9 - Wiring for Dual Anderson Euro 5912853 A01 12 of 12 Webasto Charging Systems, Inc.