FlowCon FAC6HP Installation And Operation Instruction

FlowCon FAC6HP with optional software
ADDITION TO INSTALLATION AND OPERATION INSTRUCTION
FlowCon FAC6HP with optional software
Please see operation instruction for FlowCon
FAC6HP (1F95600) to learn how the commission-
ing meter is connected to a valve and how to mea-
sure relevant values.
Installing the software.
The software can be installed on Windows XP/
Vista/7 operating systems.
Install the software thus:
1. Install the drivers for the FlowCon FAC6HP:
1.a. Insert the CD in a CD drive of a computer
(not supplied by FlowCon), and if prompted
to, choose not to install the program.
1.b. Open the folder "cp210x" (to find the folder
choose to "explore" the CD) and start the
program inside this folder.
1.c. Please follow the steps on the screen to
complete the installation and launch the
program.
1.d. Click "Install" on the pop up window "Silicon
Laboratories CP210x USB to UART Bridge
Driver Installer" when prompted.
2. Install the software for the FlowCon FAC6HP:
2.a. Go to the root folder of the CD and start the
program "setup.exe". If prompted, choose
to trust / install it (PcomPRO).
2.b. At the end of the installation (when the pro-
gram PcomPRO is first started), you will
be asked to connect a FAC6HP to the
computer. Please turn on the FAC6HP (by
pressing any button), then connect the
computer and FAC6HP with the USB cable.
The USB port on the FAC6HP is located
inside the battery box at the back of the
device inside the rubber cover.
1F95610
Denmark Dubai
- 1 -
Commissioning meter
3. Import a valve list:
3.a. When a new FAC6HP is connected to the
computer, the program will prompt a need
to create a reference file for that particular
FAC6HP (the program will idetify each
FAC6HP from its serial number). Please
accept the creation of the reference file and
await the process (this usually takes 4-5
minutes).
It is not necessary to have a FAC6HP connected
to the computer all the time working with the soft-
ware. However the list of available valves will be
imported from the FAC6HP and thus it is important
to connect it initially.
The program will wish to import the valve list from
each commissioning meter connected and by de-
fault only use valves for projects intended for a
specific commissioning meter included in the list
from that particular device.
Creating and editing projects.
The quick start offers either import of the current
project on any connected FAC6HP, creation of a
new project or opening a recent project located
in the program's default folder. When creating
or editing any project, the program window is by
default divided into 3 main parts, please see figure
1. The buttons will be explained if the mouse is
kept over the button, besides table 1 consists of a
total list of buttons.
Please start all new projects by choosing the units
that you wish to use for that project (see the upper
left part of figure 1).
After choosing the units, the setup of the project
should be defined in the project tree. The project
tree is shown in the middle part of the screen
USA Brasil
FlowCon International assumes no responsibility for mistakes, if any, in any printed material.
Singapore
05/2013