Advertisement
Advertisement
Table of Contents
Summary of Contents for enLighten Glass Board
- Page 1 Balt 4' x 6' Black Enlighten Glass Dry- Erase Whiteboard Instruction Manual...
- Page 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 Enlighten Boards...
- Page 3 20” X 30” GBoard-4 pcs. (A),(B) 4 pcs. (C), (D), (E) 4 pcs. (F) Special Note: Your new glass board requires a flat wall for mounting. Make sure the area behind the glass board is free of any high spots.
- Page 4 Tape measure, chalkline, electric drill / screwdriver, drill and screwdriver bits, stud finder and level. Illustration # 1 2.) When you have your glass board positioned, mark the wall through the mount holes that are in the board. Illustration # 2...
- Page 5 Installing the Glass Board After you have followed the guidelines from Page 3, install the correct number of wall anchors for the size board you are mounting to the wall. Install the anchors as shown in Illustration #3A and #3B.
- Page 6 To attach your Glass Board (P1) to the wall, use a Screw (D) through a Brass Mount (B), a Plastic Washer (F) ,through the hole in the board and into the wall anchor as shown in illustration # 4. Repeat this Step for each mounting hole in your board.
Need help?
Do you have a question about the Glass Board and is the answer not in the manual?
Questions and answers