Advertisement
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Screw driver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Unscrew the Power Cable Holder 1.
2. Unscrew all screws 2, and then remove the mounting angle 3.
3. Remove top cover 4, and then remove plastic panel 5.
4. Remove all of the inner cables.
5. Unscrew all screws on support 7, and then remove support 7 from the chassis.
6. Unscrew all screws on fan 8, and then remove fan 8 from the chassis.
7. Unscrew all screws on power connector 9, and then remove power connector 9 from the chassis.
8. Unscrew all screws on PCB 10, and then remove PCB 10 from the base.
9. Unscrew all screws on Part 11 , and then remove Part 11 from the base.
10. Remove all of the labels from the chassis.
11. Unscrew all screws on PCB 10-2, and then remove the insulation pad from PCB 10-1.
12. Unscrew part 10-3 from PCB 10, and then remove part 10-3.
13. Remove part 10-4 from PCB 10.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
Figure 1 Unscrew the Power Cable Holder 1 and screw 2
EL-MF877-00
Template Revision B
PSG instructions for this template are available at
Figure 2 Treatments to the product (rear view)
EL-MF877-01
Tool Size (if
applicable)
2#
Page 2
Advertisement
