Summary of Contents for INDE PLASTIK IP 190
- Page 1 IP 190 Sealing Machine Instruction Manual IP 190 Sealing Machine INDE PLASTIK Betriebsges. mbH Industriestrasse 16 52457 Aldenhoven Tel.: 02464/99130-0 Fax: 02464/99130-99 Email: info@indeplastik.de - 1 -...
-
Page 2: Table Of Contents
IP 190 Sealing Machine Contents: 1. Introduction .......................3 2. Safety information ....................3 3. Description of the individual parts ................4 4. Preparation for use ....................8 5. Operation ........................9 6. Cleaning the sealing surface .................10 7. Consumables / Repairs / Service address ............11 8. -
Page 3: Introduction
IP 190 Sealing Machine 1. Introduction The machine is used to manually seal all kinds of trays made from CPET, PP, PS and OPS with different kinds of film. Fusing and sealing can be carried out in one operation. Matching sealing frames are available for various container shapes. -
Page 4: Description Of The Individual Parts
IP 190 Sealing Machine 3. Description of the individual parts Overall view Mains switch Heating control light Temperature setting control - 4 -... - Page 5 IP 190 Sealing Machine Fuse Film roll support bracket Sealing surface Cutter Sealing frame - 5 -...
- Page 6 IP 190 Sealing Machine Film retaining bracket Mains cable Film roll Air vents Tensioning spring - 6 -...
-
Page 7: Preparation For Use
IP 190 Sealing Machine 4. Preparation for use Before using the sealing machine carry out the following preparatory steps: Inserting the film roll Insert the film as shown in the picture, (the film is unwound from the top). Make sure that the film is fed under the bracket. The film retaining bracket prevents the film from slipping out after the automatic cutting operation which takes place during sealing. -
Page 8: Operation
IP 190 Sealing Machine 5. Operation Step 1: Turn on the device using the mains witch. The light in the mains switch is illuminated. Step 2: Set the temperature setting control to the required temperature. It should be 140°C for PP and PET trays and 90°C for PS trays (The orange light goes off whenever the selected temperature is rea- ched.) - Page 9 IP 190 Sealing Machine Step 5: Grasp the top handle with both hands as shown in the illustration and, applying light pressure, press the sealing surface down until it rests on the film-covered tray. The sealing process takes about 1 to 3 seconds.
-
Page 10: Cleaning The Sealing Surface
IP 190 Sealing Machine Information on changing the film roll Turn off the mains switch and allow the sealing machine to cool before replacing the film roll. When changing the film roll do not touch the cutter. Danger 6. Cleaning the sealing surface The sealing surface should be cleaned only with water to which a commercially availa- ble detergent can be added. -
Page 11: Consumables / Repairs / Service Address
IP 190 Sealing Machine 7. Consumables / Repairs / Service address We recommend that you use only original consumable materials from INDE PLASTIC (trays and films). Only then we can guarantee optimum sealing results. We assume no liability for damage caused by using supplies other than the manufactu- rer’s consumables. -
Page 12: Technical Data
IP 190 Sealing Machine 9. Technical data Technical data: Sealing surface: 225 x 180 mm Roll width: 190 mm max Roll diameter: approx 180 mm Power supply voltage: 230 Volt Power consumption: 550 W Fuse: Net weight: 9 kg - 12 -...