Maintenance And Cleaning - Beko HTV 8746 XF User Manual

you will see a screen similar to the one below.
When Remote Control is enabled, you can only
manage and switch off the machine and follow
status on the washing machine. All functions
except child lock can be managed through the
application.
You can check the function indicator on the key
to follow whether the Remote Control function is
On or Off.
If the Remote Control function is Off, all the
operations are handled on the washing machine
and only status follow-up is allowed on the
application.
If the Remote Control function cannot be
enabled, you will hear a warning after pressing
the button. This might occur if the product is
switched on or if there is no product paired
through Bluetooth. Bluetooth setting being Off
or the washing machine's door being open are
examples for such cases.
When you enable this function on the washing
machine, said function will remain on except
for certain cases, allowing you to control your
washing machine remotely via Bluetooth.
In certain cases, it deactivates itself for
safety reasons:
• When your washing machine
undergoes a power interruption.
• When the programme knob is turned
to select a different programme or
when the product is switched off.
5.21.4 Troubleshooting
Follow the steps below if you are having problem
with controlling or connection. Observe whether
the problem persists or not after the action you
have performed. Do the following if the problem
is not resolved.
• Check whether your smart device is
connected to the relevant home network.
• Restart the product application.
• Turn Bluetooth off and on through
the user control panel.
• If the connection cannot be established
with the above processes, repeat the initial
set-up settings on the washing machine.
If the problem persists, consult an
Authorised Service Agent.
35 / EN

6 Maintenance and cleaning

Service life of product extends and frequently
experienced problems will be reduced if it is
cleaned at regular intervals.
6.1 Cleaning the detergent drawer
1 Remove the siphon by lifting it from behind
as shown in the picture. After performing
the below mentioned cleaning procedures,
replace the siphon back to its seating
and push its front section downwards to
make sure that the locking tab engages.
C
INFORMATION
• If more than normal amount of water and
softener mixture remains in the softener
compartment, the siphon must be cleaned.
2. Wash the detergent drawer and the siphon
with plenty of lukewarm water in a washbasin.
In order to prevent the residues to contact
your skin, clean it with an appropriate
brush by wearing a pair of gloves.
3 Insert the drawer back into its place after
cleaning and make sure that it is seated well.
6.2 Cleaning the loading
door and the drum
For products with drum cleaning programme,
please see Operating the product - Programmes.
C
INFORMATION
• Repeat Drum Cleaning process in every 2
months.
• Use an detergent /anti-limescale suitable
for the washing machines.
Clean the detergent
drawer at regular
intervals (every 4-5
washing cycles)
as shown below
in order to prevent
accumulation of
powder detergent in
time.
Washer-Dryer / User Manual