RHINO PSB24-BCM960S Instructions Manual

RHINO PSB24-BCM960S Battery Control Module
READ INSTRUCTIONS BEFORE INSTALLING OR OPERATING
THIS DEVICE. KEEP FOR FUTURE REFERENCE.

General Description

The PSB24-BCM960S battery control module is designed to
support a 24V system with up to 40A output and 4.5 minutes
back up time for 15AH battery capacity. It offers a wide input
voltage from 24-28V and a wide operating temperature range
from -20°C to +60°C. This product comes with dry contacts for
battery management signals and LED indicator for battery status.
The rugged compact aluminum case is shock and vibration resis-
tant according to IEC 60068-2.

IMPORTANT SAFETY INSTRUCTIONS

• Retain these instructions. This manual contains important safety
instructions.
• When replacing batteries, only use the same type of batteries as
described in the Specifications.
• Proper disposal of batteries is required. Refer to the relevant local codes
for disposal requirements.
• Switch main power off before connecting or disconnecting the device.
Risk of explosion!
• If the orange status LED is on steady, this indicates a failure in the
installation. In this case, do not turn on power supply while the battery
is connected. Danger of explosion!
• To guarantee sufficient convection cooling, keep a distance of 50mm
above and below the device as well as a lateral distance of 20mm (for
vertical mounting) or 50mm (for horizontal mounting) to other units. See
Figure 4.
• Please note that the enclosure of the device can become very hot
depending on the ambient temperature and load of the power supply.
Risk of burns!
• The mains power must be turned off before connecting or
disconnecting wires to the terminals!
• Do not introduce any objects into the unit!
• Dangerous voltage present for at least 5 minutes after disconnecting all
sources of power.
• This is a built-in unit and must be installed in a cabinet or room
(condensation free environment and indoor location) that is relatively
free of conductive contaminants.
• CAUTION: FOR USE IN A CONTROLLED ENVIRONMENT.
Risk of electrical shock, fire, personal
injury or death.
1. Turn power off before working on the device.
2. Make sure the wiring is correct by following all local
and national codes.
3. Do not modify or repair the unit.
4. Use caution to prevent any foreign objects from
entering into the housing.
5. Do not use in wet locations.
6. Do not use the unit in area where moisture or
condensation can be expected.
FOR TECHNICAL ASSISTANCE CALL
RHINO Battery Control Module PSH-BCM360S Operating Instructions –1st Edition, Rev. A 11/2018
tPWR-97
Power Supplies
.
3PET
Highlights & Features
• Full corrosion resistant Aluminium chassis
• Suitable for 24V system up to 40A
• Built-in diagnostic monitoring for DC OK, Discharge and Battery Fail by
relay contacts
• LED indicator for DC OK, Battery Fail, DC Input, Battery Reverse Polarity
and Battery Discharge
• High MTBF > 500,000 hrs as per Telcordia SR-332
• Wide operation temperature range from -20°C to +60°C
• Conformal coating on PCBA to protect against chemical and dust
pollutants

Device description (Fig. 1)

(2)
(1)
Figure 1
(1) Input & Output/Battery terminal block connector
(2) Signal terminal block connector
(3) LED display status
(4) Universal mounting rail system
249074
E198298
(3)
(4)