Related Manuals for Zamp Solar SCC1011
Summary of Contents for Zamp Solar SCC1011
- Page 1 Solar Controller / Battery Charger SCC1011 Input: DC12V / 24V Solar panel (Max. 50V) Output: DC 12V / 24V 40A User’s Manual...
- Page 2 ●Surface Mount or Flush Panel Mount options. ●Conformal-coating circuit boards and plated terminals apply to hostile environments. SCC1011 For use with 12/24Volt Solar Panel; Suitable for Solar panels up to 760 Watts on 12V mode; 1520Watt on 24V mode...
- Page 3 WARNING – IMPORTANT PLEASE READ ● This charger is designed for indoor use only and should never be exposed to rain. ● Do not disassemble the controller. Take to a qualified person if the unit requires repairing. ● Lead acid, LiFePO4, LTO, batteries can be dangerous. Ensure no sparks or flames are present when working near batteries.
-
Page 4: Wiring Connections
Please refer to the wire size chart below to determine the minimum size wire needed for each connection. This will also ensure you get the best performance out of your solar regulator. SCC1011 SOLAR BATTERY 50A FUSE Battery Connection Solar Array Connection... -
Page 5: Charging Stages
Press BATTERY TYPE button and hold for 3 seconds to go into your battery type selection mode, the battery type you select will be shown on the LCD meter, the default setting is AGM Battery; the controller will automatically memorize your battery type setting. - Page 6 Soft Charge- When batteries suffer an over-discharge, the controller will softly ramp the battery voltage up to 10V. Bulk Charge-Maximum current charging until batteries rise to Absorption level Absorption Charge-Constant voltage charging, and battery is over 85%. Equalization Charge*-Only for WET battery type, when the battery is deeply drained below 10V, it will automatically run this stage to bring the internal cells as an equal state and fully complement the loss of capacity.
- Page 7 ABNORMAL OPERATION MODE Solar panel abnormal LCD display LED indication LCD backlight mode Solar panel weak Flash Solar panel reverse Flash connection Flash Solar panel over voltage Flash (> 26.5V) Flash Battery abnormal mode LCD display LED indication LCD backlight Battery disconnected or Flash less than 3.0V...
-
Page 8: Specifications
SPECIFICATIONS Electrical Parameters Rated solar panel short circuit current Max. Normal input Solar cell array voltage 15-22 Max. solar cell array voltage (output has no load) Max. The controller lowest operating voltage (solar or battery side) Maximum voltage drop-Solar panel to battery 0.25 Max. - Page 9 3.9in 100.0mm...