Related Manuals for Crane 702262
Summary of Contents for Crane 702262
- Page 1 3-10 Assembly INFLATABLE WATER PARK Owner's Manual 400 x 335 x 230 cm Approximate Size Inflated PRODUCT CODE 702262 Manual version: 2021 V1 Date of issue:2021-04-21...
-
Page 2: Table Of Contents
WELCOME Congratulations on choosing to buy a Crane product. In the event you require assistance with your purchase please contact one of our experienced customer service team on 1300 780877 before considering a return of product to ALDI. Please read instructions carefully before use. -
Page 3: Safety Warning Instructions
CAUTION:ELECTRICALLY OPERATED PRODUCT The blower is not recommended for children under 14 years of age. As with all electric products, precautions should be observed during handling and use to prevent electric shock. WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Do not use extension cords with this product. -
Page 4: Part List
Part list (A) 1 Inflatable water park (B) 1 Blower (C) 1 Carrying Bag (D) 2 Blower (E) 7 Water Park Stakes Stakes (F) 4 Vinyl Patches (G) 1 hose assembly kit (H) 4 inflatable ball (I) 7 Fabric Patches SAFETY WARNINGS ELECTRICAL BLOWER ：... -
Page 5: Safety Warnings: Set Up
SAFETY WARNINGS: SET UP ADULT SUPERVISION AND SET UP REQUIRED. This product should be inflated or deflated only by a competent adult. Follow all instructions provided. WARNING! Falls onto hard surfaces can result in head or other serious injuries. Never place on concrete, asphalt, wood,packed earth, or other hard surfaces. Carpet over hard floors may not prevent injury. - Page 6 SAFETY WARNINGS: FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESUL T IN SERIOUS INJURY OR DEATH. 3-10 91-152 159 kg. 53 kg. years Maximum number Total weight limit User height: Individual of children:3 on slide and pool: maximum 152cm, weight limit: 159 kg.
-
Page 7: Minimum Clearance Zones
• Never use product as a floatation or life saving device. • Children can drown in very small amounts of water .Empty the pool when not in use. • Do not install the paddling pool over concrete,asphalt or any other hard surface. •... -
Page 8: Water Park Placement
Water Park Placement Slide Climbing Wall Designate a flat, level surface that allows for 2m of minimum clearance around the Water Park. NOTE: DO NOT place the Water Park on a hard surface like asphalt, concrete or packed earth as both serious bodily injury and damage to the Water Park could result. -
Page 9: Water Park Assembly & Set Up
Water Park Spray Assembly Turn on the garden hose and adjust the pressure as desired. Make sure that a steady spray of water comes out of the sprayer and keep the slides wet. Set Up CAUTION CAUTION Remove Water Park from its packaging Do not touch electrical hazard... - Page 10 Attach longer fabric tube to blower unit making sure the tube is not twisted. Tie off the short Air Outlet Tube tightly to make a good seal. NOTE: Position the blower motor perpendicular and level to the Water Park. Make sure that the blower is upright on a stable surface.
- Page 11 Secure the blower to the ground with the provided stakes. Secure the Water Park to the ground with the provided stakes. To prevent tripping, pull the stake loops all the way out, then drive stakes completely Switch power on. into the ground. Make sure the Hose Assembly is attached to the Water Park as shown.
-
Page 12: Water Warnings
Water Warnings IMPORTANT: To avoid serious injury or death, heed all warning signs that are printed on the Water Park. These signs are shown below: DANGER WARNING BE CAREFUL! SOME OF THE WATER PARK SURFACES ARE NO DIVING OR JUMPING SLIPPERY AND MAY PRESENT A TRIPPING HAZARD. -
Page 13: Storage
As the Water Park deflates, water will find the lowest point and drain from the collapsing pool walls. Remove stakes and move the Lift the bottom of pool from one side to Water Park away from the drained water to a dry area. the other to let the remaining water drain. -
Page 14: Repair Patch Instructions
REPAIR PATCH INSTRUCTIONS Replace defective parts in accordance with the instructions. Please keep for future reference. 1. Deflate the item, clean the area and allow to dry thoroughly. 2. Cut a portion of the patch to the size needed and round the corners.(See Fig.1&2). 3. -
Page 15: Faq
FAQ (Trouble-shooting advice) 1. Question: Does the blower have to run continuously while the kids are playing on it? Answer: Yes,the blower does have to run continuously. 2. Question: Can the water park be set up on concrete instead of grass? Answer: No.
Need help?
Do you have a question about the 702262 and is the answer not in the manual?
Questions and answers