Related Manuals for PulseTech 890PT
Summary of Contents for PulseTech 890PT
- Page 1 741X890 OPERATORS MANUAL Read entire manual before using this product. www.pulsetech.net...
-
Page 2: Main Features
State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov. Tester should not be exposed nor be used in extreme moisture conditions, such as rain / snow or damage to the tester can result. www.pulsetech.net – 1... -
Page 3: Personal Safety Precautions
Note: Each time you connect the tester to a battery, the tester will run a quick cable verification to ensure a proper connection through the output cables to sensors in the clamp jaws. If the connection checks out OK, the tester will www.pulsetech.net – 2... -
Page 4: Paper Replacement
In this case, the printer will always be cooled down enough and ready for printing the result of the second test. If the integrated printer does start to get warm, please have it rest for a while and cooled down before using the printing function again. www.pulsetech.net – 3... - Page 5 6. Select Rating (Available rating: CCA). 7. Select Capacity: 25~3000 CCA/SAE. 8. Start Testing: The 890PT will automatically perform a battery test. Use the directional keys to review the test result. Or, move the cursor to the printer icon to print out the result.
-
Page 6: Surface Charge
SURFACE CHARGE Note: If the 890PT detects the surface charge, the 890PT will pop up a notification asking the user to turn on loads/headlights for 15 seconds to eliminate the surface charge. If the 890PT keeps popping up the notification “Turn on loads & headlights for 15 seconds”... - Page 7 Idle Voltage 13.87V <<NEXT>> <<NEXT>> 6. Turn on loads and rev engine for 15 seconds. (The 890PT will countdown 15 seconds) 7. Once completed, the ripple & load test results are displayed. Ripple Test Rev the engine up System System Turn on loads.
- Page 8 The normal high limit of a typical automotive regulator is 14.7 volts +/- 0.05. Check manufacturer specifications for the correct limit, as it will vary by vehicle type and manufacturer. www.pulsetech.net – 7...
- Page 9 Check the connections from the alternator to the battery. If the connection is loose or heavily corroded, clean or replace the cable and retest. If the belts and connections are in good working condition, replace the alternator. www.pulsetech.net – 8...
-
Page 10: Date And Time
2. Press ENTER to confirm the setting 3. FRANCAIS and return to the setting menu. Or press the BACK key to discard the change and return to the setting menu. DATE & TIME Select DATE & TIME to adjust the time. www.pulsetech.net – 9... - Page 11 Valves in the top of them that opens when a preset pressure is realized inside the battery and let’s the excess gas pressure out. Then the valve resets itself. Gel and AGM batteries are examples of VRLA battery types. www.pulsetech.net – 10...
- Page 12 315-489-8823 • rjohnson1@twcny.rr.com Tom Pigorsh • Field Support Western US Military Programs 719-331-0329 • tom.pigorsh@comcast.net Adam Hagenston • North US National Guard/Reserve Component/AF 406-794-4218 • adam.hagenston@yahoo.com Briza Justice • Government & Military Quotes and Sales 817-329-6099 Ext. 152 • bjustice@pulsetech.net 741x890_Manual_03/23v1d...
Need help?
Do you have a question about the 890PT and is the answer not in the manual?
Questions and answers