Advertisement
BEFORE
YOUR
FIRST
BREW
To prime your brewer:
1 Plug it into the wall and
turn it on.
2 Fill the water reservoir
to the Full line with fresh
water and place it on the
base.
3 Remove the Ninja Pod
Adapter and slide the
Sliding Lid into the closed
position. (Refer to the
steps on page 3)
4 Place the empty carafe
under the brew basket
and run a Full Carafe,
Classic Brew.
Once the brew is complete,
discard the water and
you're ready to brew.
If you live in a high-altitude
area, running a calibration
brew is required. Not running
a high-altitude calibration
brew in a high-altitude
area will result in excessive
steaming during brewing.
Refer to page 7 of the Owner's
Guide for instructions on
running a high-altitude
calibration brew.
2
For how-to videos and more, visit ninjakitchen.com
HERE'S WHAT'S IN THE BOX
NINJA DUALBREW
NINJA
POD ADAPTER
Comes fully installed in
the brewer. Always ensure to
insert it over the brew basket
when brewing pods.
BREW BASKET
Comes fully installed in
the brewer. It must always
be inserted when brewing
pods or grounds.
60 OZ.
THERMAL CARAFE
Keeps coffee hot, no
warming plate required.
FROTHER WHISK
60 OZ. REMOVABLE
WATER RESERVOIR
NINJA
SMART SCOOP™
Use this to measure
coffee grounds.
PAPER FILTER KIT
Fold along the seams
before inserting firmly
into brew basket.
FILLING THE WATER RESERVOIR
FULL
LOCKING AND REMOVING THE NINJA POD ADAPTER
The Ninja DualBrew Pro Coffee System comes with a unique Ninja Pod Adapter already installed on the
brewer. Always ensure the adapter is installed over the brew basket.
REMOVE
LOCK
1. Once the adapter is installed in the brewer,
make sure the position indicator on the left side
of the adapter is aligned with LOCK by pulling the
handle toward you. Then, lift to open the handle,
insert a pod, firmly push down on the handle to
pierce the pod, and begin programming your brew.
NOTE: The Ninja Pod Adapter is compatible only with K-Cup pods. It is not compatible with
reusable K-Cup filters. If using ground coffee, use the Grounds mode with a paper or permanent filter
(sold separately) to brew a single-serve size.
SLIDING LID
The sliding lid is used only when brewing loose coffee grounds. To use it, first remove the Ninja Pod Adapter.
Then, using the handle on top of the brewer, slide the lid toward you until it firmly clicks into place.
OPEN
FILL TO THE FULL LINE
Fill up to, but do not exceed,
the Full line.
REMOVE
LOCK
2. To uninstall the adapter, remove the used pod and
close the handle. Push the handle away from you
so the position indicator is in the REMOVE position.
Then, using the edges on the left and right, lift the
adapter out of the brewer.
CLOSED
3
Advertisement
