Larson Electronics SLEDB-CL1B-MS-MT-AT-PA-12V Instruction Manual

LED Strobe, Motion Sensor - 110dBA Horn - Back Plate - Adjustable Control Timer
Thank you for purchasing the Larson Electronics SLEDB-CL1B-MS-MT-AT-PA-12V LED Motion Alarm System with Horn.
Follow the steps below for installing and maintaining the unit.
WARNING: Do not attempt installation until you are familiar with all warnings, precautions, and procedures outlined
within this instruction sheet.
INSTALLATION PRECAUTIONS
• Do not install fixture in any classified location where the marked operating temperature exceeds the ignition
temperature of the atmospheres.
• Consult fixture nameplate for the suitability ambient temperature shown on the nameplate.
• Refer to fixture nameplate for minimum supply wire temperature rating.
• Verify that the supply voltage agrees with fixture rating as indicated on nameplate.
• All local and national electrical/building codes must be followed when installing this fixture. For code interpretation,
consult your local authority.
• Product must be intact and all cap threads fully engaged. Do not use if cracked or damaged.
The SLEDB-CL1B-MS-MT-AT-PA-12V from Larson Electronics is an LED Motion Alarm System w/ Horn for industrial
use. This unit features a Class I LED strobe light, a user settable control timer, and an audible horn that can produce
eight different tones to sound levels up to 110 dBA @ 10 feet. A pre-drilled aluminum base facilitates wall, ceiling, or
surface mounting applications.
Installation
We strongly recommend that only a licensed electrician install this product.
WARNING: Make sure that the power is disconnected before installing. This fixture is heavy and must be mounted to a
surface that can structurally support the load. Secure the unit firmly to the surface. Failing to comply can result in
breakage, allowing the fixture to fall, which can cause serious injury or death.
It is strongly suggested to use two licensed electricians to proceed with the final mounting of the fixture to avoid any
possible personnel injury or damage to the fixture. Depending on mounting height and scaffolding, a hydraulic man–lift or
two good quality ladders should be used.
WARNING: Check the fixture label to ensure correct input voltage and frequency!
There are mounting holes on either side of the unit for surface mounting to a wall, ceiling or any flat surface. Mount the
unit in any location except horn skyward.
Run cable and wire the unit according to the labeled wiring. Adjust the motion sensor prior to energizing if required. Be
sure to follow all safety protocols and codes for the location.
Use only voltage specified on product nameplate.
Motion Sensor Operation
Wiring the Unit
Connect N, L with power
Connect N, L' with load
Larson Electronics, LLC
12V LED Motion Alarm System w/ Horn
Instruction Manual
*Voltage varies on unit purchased.
Phone: (877) 348-9680 Fax: (903) 498-3364
SLEDB-CL1B-MS-MT-AT-PA-12V
www.larsonelectronics.com
1 of 3