Page 1
1. Wrap the strap around the package. Load one end of the strap into the Buckle 100. Load the other End 102 into Buckle 100. Manually, take out the excess strap by pulling on End 102. Place the MUL-375 approximately 10” out of the Buckle 100 as shown on Fig. 2.
Page 2
Fig. 3 3. Apply tension by ratcheting Tension Handle 01 as shown on Fig. 4. Fig. 4 4. Once satisfactory tension is achieved the strap is ready to be cut. Push down on the Tension Handle 01 until the strap is cut and slide the tensioner to the right to release the strap from under the Gripper Foot 25 as shown on Fig.