Summary of Contents for Mount-It! MI-7157
- Page 1 Installation Manual SKU: MI-7157 Multifunctional Thin Client CPU Holder HAVE QUESTIONS? Monday - Friday from 8:00am - 4:00pm PST support@mount-it.com (855) 925-5668 www.mount-it.com...
- Page 2 Thank you for choosing Mount-It!! Supplied Parts & Hardware (x1) (x1) (x1) (x3) Pole Mount Bracket Mount Strap Adhesive Pad (x4) I(x4) (x2) (x8) (x4) M5x25 M4x12 Washer ST4.8x16 Screw Required Tools Phillips Screwdriver lbs capacity...
- Page 3 Step 1 Step 2A POLE MOUNTING OPTION: Connect the Pole Mount Bracket to the back side of the Loosen the knobs and split the Mount into two pieces. pole and attach the Mount with the base to the front of the pole using M5x25 screws. Attach the Adhesive Pads as shown on the image below.
- Page 4 Step 2B (Continued) Step 2B WALL OR UNDER DESK MOUNTING OPTION: Attach Adhesive Pads to inside face of both Mount ends. Use the outer holes on the Mount with the base to mark drilling locations on the wall or under desk. Drill holes no deeper than 5/8” (16mm) using a 3/16” (2.4mm) bit.
- Page 5 Step 2C (Continued) Step 2C VESA MOUNTING OPTION: Attach the smaller Mount piece to the VESA mount (75x75 mm or 100x100 mm patterns) using the 4 x M4x12 screws, washers and nuts. Attach the Adhesive Pads as shown on the image below. Attach the Mount with the base using the knobs.
- Page 7 Visit us at www.mount-it.com for product registration and warranty information. Our US based customer service team is support@mount-it.com standing by to answer any questions you have about your Mount-It! product. (855) 915-2666 Available by phone Monday - Friday from 8:00am to 4:00pm PST. www.mount-it.com Chat live with an agent on our website!