Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Nordic JR-L0218D
Summary of Contents for Nordic JR-L0218D
- Page 1 18V CORDLESS JOB SITE RADIO OPERATING MANUAL JR-L0218D...
-
Page 2: Product Specification
NORDIC PRODUCT SPECIFICATION Voltage: USB Output: 5V 1.0Ah DAB Frequency: 174-240MHz FM Frequency: 87.5-108MHz GENERAL POWER TOOL SAFETY WARNINGS Read all safety warnings and instructions. Failure to heed warnings and follow instructions may result in electric shock, fire and/or serious injury. -
Page 3: Additional Safety Instructions For Batteries And Chargers
NORDIC increased risk of an electric shock if your body is earthed. • Do not expose to rain or wet conditions. If water gets inside, it will increase the risk of an electric shock. • If operating in a damp location is unavoidable, use a power supply protected by a residual current device (RCD). - Page 4 NORDIC CHARGERS • Never attempt to charge non-rechargeable batteries. • Have defective cords replaced immediately. • Do not expose to water. • Do not open the charger. • Do not probe the charger. • The charger is intended for indoor use only.
-
Page 5: Operation
NORDIC Do not incinerate battery pack or charger Protect from the rain. OPERATION Before using the equipment: BATTERY CHARGER The lithium-ion battery can be charged at any time and will not develop a “memory” when charged after only a partial discharge. It is not necessary to run down the battery pack charge before recharging. Remove the battery pack from the tool when convenient for you and your job. -
Page 6: Control Method
NORDIC Pull the battery pack out and remove it from the tool. WARNING: Always remove the battery pack before making adjustments to the equipment. Be sure to read the following information before you put the cordless equipment into operation: Charge the battery pack with the charger. -
Page 7: Cleaning And Maintenance
NORDIC DAB+ OPTIONS • Menu Options: Press and hold the ‘info/menu’ button until you see ‘Full Scan’ • Press the tune +/- buttons to cycle the options and press the dial to select. The options here are here are Full scan > Manual Tune > DRC > Prune > System FULL SCAN •... - Page 8 NORDIC...
- Page 9 NORDIC...
- Page 10 NORDIC...
- Page 11 NORDIC...
- Page 12 NORDIC...
- Page 13 NORDIC...
- Page 14 NORDIC...
- Page 15 NORDIC...
- Page 16 NORDIC...
- Page 17 NORDIC...
- Page 18 NORDIC...
- Page 19 NORDIC...
- Page 20 NORDIC...
Need help?
Do you have a question about the JR-L0218D and is the answer not in the manual?
Questions and answers