Infinite L-com PXCAPCKN Series User Manual

• Do not use in environments that are flammable or contain explosive
or corrosive gases, chemicals, steam or humidity.
• Do not use it in environments with water, oil or other liquids.
• Please do not dissemble, repair or rebuild this product.
• Do not use beyond the recommended voltage and current range.
• Please observe electrical polarity when making connections.
• Please connect the load correctly.
• Please avoid short-circuiting the load.
• Please do not operate if the product is broken.
• When disposing the tester, please treat it as industrial waste.
• Do not use in direct sunlight.
• Do not install in a place that is easily accessible to anyone except the user.
• Do not install in an environment with excessive vibration which may cause direct
shock to the product.
• Placing the product's wire and power lines in the same piping may cause disturbance,
malfunction or even destruction of the product.
• The extension wire requires a wire with a cross-sectional area of 0.3 mm or more and a
length of 100 m or less. In case the Korean S-mark certification model is used as a
certification product, please ensure that it is set below 10 m.
• If force is applied to the wire, please refer to the following: below 40N, 0.1N-m torque
less, 20N or less and 3 kg below the bending.
• When the power is turned on, the product can be detected within 200 ms. Hence, if the
load and product are connected to different power supplies, the product's power must be
turned on first.
• When the power is turned off, an output pulse may be generated. Please cut off the
power supply of the load or load line to prevent the same.
• Please avoid using thinner, gasoline, acetone, kerosene or other solvents to clean the
product.
Do not exceed the voltage range above the input or DC power input as this may break
or burn the AC power supply.
Please avoid short-circuit as it may break or burn the load. The load short-circuit hold
must be used within the rated voltage under the correct polarity of the power supply.
Do not miswire or incorrectly wire the device as it may cause cracking or burning.
Please add the load and then wiring to avoid direct load power supply into the internal
prime which may lead to breakage or burning.