Advertisement
Quick Links
FSC-BP301W serial WIFI adapter
instruction manual
10
9
1、SMA antenna connector
2、 Power off/slave mode/master mode
3、 Green communication indicator
4、 Type-C charging interface
5、 Blue status indicator
6
7
8
FSC-BP301W Datasheet
3
4
5
6、 Red charging indicator
7、 Tighten the screws
8、 Restore factory settings button
9、 DB9 female connector
10、 SMA antenna
1
2
Advertisement
Summary of Contents for Feasycom FSC-BP301W
- Page 1 FSC-BP301W Datasheet FSC-BP301W serial WIFI adapter instruction manual 1、SMA antenna connector 6、 Red charging indicator 2、 Power off/slave mode/master mode 7、 Tighten the screws 3、 Green communication indicator 8、 Restore factory settings button 4、 Type-C charging interface 9、 DB9 female connector 5、...
- Page 2 FSC-BP301W Datasheet 1.Introduction FSC-BP301W is an RS232 serial port WIFI adapter with built-in lithium battery and charging circuit, which can be used in situations without external power supply. FSC-BP301W has abundant AT command, complete function, efficient and safe communication and strong anti-interference ability.
-
Page 3: Specifications
FSC-BP301W Datasheet 3.Specifications 3.1 Technical parameters WIFI specification：802.11 a/b/g/n 1x1, 2.4GHz & 5GHz Frequency：2.400 ~ 2.484GHz; 5.18 ~ 5.825GHZ. Transmission rate：54Mbps in 802.11g , 150Mbps in 802.11n, 54Mbps in 802.11a ：(2.4GHZ) 17.5 dBm(11 b),15.5 dBm(11 g), 13.5 dBm(11 n) TX power (5GHZ): 16dBm(11 a) Working current：450mA (MAX) -
Page 4: Hardware Structure
FSC-BP301W Datasheet 3.2Factory parameters The default parameters of FSC-BP301W when leaving the factory are as follows. Some parameters can be modified by sending AT commands to the adapter. For details, please refer to the AT command manual. Baud rate ：115200bps Verification：None... -
Page 5: Product Packing List
FSC-BP301W Datasheet To set up FSC-BP301W through AT commands, it usually needs to be operated on a computer. So first, you need to establish a serial port debugging environment on your computer. Serial debugging requires the computer to have a free serial port, and it also needs to run the serial debugging software on the computer. - Page 6 FSC-BP301W Datasheet 7.FAQ Question: I use the Feasycom serial port tools to debug FSC-BP301W, why couldn’t it return OK after sending the AT test command? Answer: It is probably that the serial port parameter selection is incorrect, please check the parameters of serial port number, baud rate, data bit, stop bit, check method, etc.