There is a range of up to 1.6 km from the Sensors to the Alert Receiver Plus. The Alert Receiver Plus allows for the connection of two accessories which will allow you to hear the alerts at other points on your property.
Page 4
POWERING YOUR RECEIVER Connect the power adapter to the Alert Receiver Plus and then into a power outlet. SENSORS TO RECEIVER If you are connecting Accessories to your Receiver, follow instructions on page 6-7 before configuring the Sensors to your Receiver.
4. Once configured, press and hold the MODE button until the lights on the Receiver stop flashing. 5. To test the Kit, activate the Sensor which should sound on your Receiver. Configuring more than one Sensor to Receiver Repeat the process above, selecting a different tune for each Sensor to help you differentiate which Sensor has been activated.
Lights Sound 12VDC alert length O F F Dip 1 and 2: Alert Receiver Plus notification settings • when your Sensors are activated. We suggest you leave these alone. Dip 3, 4, 5: these are the settings for your connected •...
CONNECTING ACCESSORIES • The terminals work with low voltage wiring only. • The Alert Receiver Plus has two relay outputs (NO, COM, NC) and a 12 VDC (+ and –) output terminal. RELAY 1 RELAY 2 12 VDC Determining which Terminal to connect to If you have purchased the Extension Whistle, Siren or Bell from us, these will be connected to the 12VDC terminals.
Page 8
NE W ZEA LA ND www.bealert.co.nz | 0508 242 333 A U STR A LI A www.bealert.com.au | 1300 588 195 info@bealert.co.nz...