Bosch WAN24124AU User Manual And Installation Instructions page 40

en Troubleshooting
Fault
The door cannot
be opened.
The water is not drain-
ing.
40
Cause and troubleshooting
– –– is activated.
Continue the programme by selecting Spin
▶
and pressing Start / Reload
Drain
→ "Resuming the programme when the programme
status is Rinse Hold", Page 30
The temperature is too high.
Wait until the temperature has dropped.
▶
Cancel the programme.
▶
→ "Cancelling the programme", Page 29
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 23
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 46
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 33
▶
– –– is activated.
Continue the programme by selecting Spin
▶
and pressing Start / Reload
Drain
→ "Resuming the programme when the programme
status is Rinse Hold", Page 30
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Pump cover is not correctly assembled.
Correctly assemble the pump cover.
▶
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
or
.
or
.