Page 1
5. General Specifications: SL Bill Validator CURRENCY AND INTERFACES See Software Description document User’s Guide Single Width Bulk Loading Validator with Mounting ELECTRICAL SPECIFICATION: Bracket and Adapter Operating Maximum Operating Maximum Current Voltage Current SLB-1043 12 V DC Idle: 300 mA Short spike (50 mS or less): 6.0 A Hardware part # Bill processing: 1.3 A...
Page 2
1. Typical DIP Switches Setting 3. Power connections To access switches open the back lid. Switches are located on the right side of +12 V lines must be connected together directly at the connector. the lid, as observed from the bezel. The “up” state is defined as the switch position closer to the top cover of the lid.