Table of Contents
Advertisement
INSTALLATION and OPERATION MANUAL
C-1LIM.:0,5A/250V~;
C2LIM.:10(2,5)A/250V~;
Terminal – circuit breaker or
switch-on contacts.
Switch-on action – 2B.
Place of installation – normal.
Type of wire – M20 x 1.5.
WARNING !
All
installation
including manual adjustments,
must be fulfilled by a qualified
specialist following all safety
conditions.
INSTALLATION AND CONNECTION .
Safety instructions:
Before connecting the thermostat, make
sure that THE UNIT TO BE THERMALLY
CONTROLLED (water heater, pump, etc.)
IS NOT CONNECTED to the power supply
network, and is in compliance with the
instructions in Figure
sheme 2
а) ) See scheme 3 and scheme 4.
operations,
sheme 3
9
sheme 4
b)Unscrew the three bolts and remove
the front part of the thermostat. Unravel
the power supply wires and connect them
to the terminals of the thermostat
(Figure 5) following the instructions.
sheme 5
sheme 6
Advertisement
Table of Contents
