Battery level indication
The display indicates the approximate levels of
the battery status as follows:
100%
75%
50%
A flashing battery screen indicates that
»
the battery is low. The player saves
all settings and switches off within 60
seconds.
Note
•
Rechargeable batteries have a limited number
of charge cycles. Battery life and number of
charge cycles vary by use and settings.
•
The charging animation stops and the
icon is displayed when the charging process is
completed.
Tip
•
You can conserve battery power and increase
the play time of CAM if you ensure that the
shortest timer setting is selected. (To check/
adjust the timer settings, set the mode selector
to
and then select [Display Settings] >
[Backlight timer].
Software loaded on the CAM
CAM comes with the following software:
Philips Songbird (helps you update the
•
firmware of CAM and transfer your
media files).
Files loaded on the CAM
The following files are loaded on CAM:
•
User Manual
•
Frequently Asked Questions
•
Safety and warranty information
•
Worldwide warranty information
EN
8
25%
0%
Update CAM
CAM is controlled by an internal program
called firmware. Newer versions of the
firmware may have been released after you
have purchased CAM.
The software program called Philips Songbird
can use your computer to check for firmware
updates that are available on the Internet.
Install Philips Songbird on your computer
(see chapter Install software) and follow the
instructions to update (see chapter Manually
verify / update the firmware).
Note
•
Your music files are not affected by a firmware
update.
Manually verify / update the firmware
1
Ensure that your computer is connected
to the Internet.
2
Connect CAM to the computer
(see section Connect and charge for
instructions).
3
On your computer, click Start >
Programs > Philips > Philips Songbird to
launch the Philips Songbird application.
4
Select Tools > Updates
» Philips Songbird checks for updates
and installs new firmware from the
Internet, if available.
5
Follow the on-screen instructions to
update the firmware of CAM.
6
Wait until the update is completed, then
disconnect CAM from the computer.
CAM restarts after the firmware is
»
updated and is ready for use again.