Advertisement
Using the Included Wall-Mount Bracket
The included wall-mount bracket makes it easy to attach the SB-40P to a wall built with standard 16-inch-on-center studs.
To mount the bracket:
1. Use a stud finder to locate the two wall studs closest to the horizontal center of the video screen.
2. Use a pencil to mark a point between these two studs and 6 inches below the bottom edge of the television chassis
or projection screen.
3. Use a ¼" bit to drill a hole in the wall.
Note: Make sure there are no electrical wires, conduits, pipes or vents behind the spot you've marked.
4. Insert the included wall anchor, and tap it in very gently with a hammer.
Note: Drill only as deep as needed to penetrate the wall.
5. Align the center mounting hole on the included mount with the wall anchor, and secure it with the screw provided.
6. Use a spirit (bubble) level to assure that the mount is perfectly leveled, then use the four included long screws to attach
the mount to the wall (Diagram 2).
Note: Make sure the screws go into the wooden studs behind the wallboard (Diagram 3).
7. Attach the speaker wires to the soundbar, then lift the soundbar onto the wall mount so the mount mates with the
bracket mounted on the back of the speaker (Diagram 4).
8. Press down lightly on the soundbar to make sure it's firmly seated on the bracket (Diagram 5).
9. Slide the soundbar horizontally so it is centered with the video screen (Diagram 6).
Diagram 2 Use Included Screws to Attach the Bracket to Wall
Diagram 3 Be Sure Screws Go Into The Wooden Studs Behind Wallboard
4
Advertisement
