Page 3
Setup the Link Charging Adapter Charging Dock Step 1: Set Up the Charging Dock To set up your charging dock, connect the charging cable and adapter to a power or wall outlet.
Page 4
Step 2: Power On Link+ Next, plug the Link+ into the charging dock. The Link+ will automatically power on, and the LiveCare logo will appear on the screen. (This process could take up to 2 minutes.) Note: Always leave the Link+ on the charging dock.
Page 5
Step 3: Accept Terms and Conditions Once the Link+ powers on, please accept LiveCare Terms and Conditions and RPM Consent Form.
Page 6
Step 4: Your Link+ is Ready! Your Link+ is set up and ready to take your vital signs.
Page 7
How to Take Blood Pressure Step 1: Connect Blood Pressure Cuff Insert the connector with cuff tube into the air socket located on the left side of the blood pressure monitor. (See picture) Step 2: Wrap cuff around your arm Rest your left arm flat on the table or arm of a chair.
Page 8
How to Take Pulse Power/Start Battery Button Indicator Pulse Rate Oxygen Saturation Step 1: Press the “Start” button Place the Pulse Oximeter on the finger. (See Proper Usage Recommendations) Press the “Start” button, and the Pulse Oximeter will begin to take your pulse.
Page 9
Emergency Response Feature Step 1: Press red emergency button On the Link+ device, press the red emergency button and hold for 2 seconds to call for help.
Page 10
Step 2: Confirmation screen After holding down the emergency button you will see a confirmation screen asking if you have an emergency. If the request did not go through, you will see a screen prompting you to call 911.
Page 11
Proper Usage Recommendations Proper usage of your Blood Pressure Monitor and Pulse Oximeter is very important for taking accurate vitals Blood Pressure Monitor Don’t eat or drink anything in the half hour before you take your blood pressure. Sit in a confortable chair with your back supported for at least 5 minutes before your reading.