Elesta RZM610A010 - Wireless Receiver Installation Instructions

Mounting

The wireless receiver is connected to the D-bus of the controller. The connectors are located under the cover at the bottom of the wireless receiver.
The green LED on the receiver indicates the correct functioning.
The internal red LED next to the terminals shows the following states

• Continuously ON: No wireless device registered at the controller
• Continuously OFF: At least one wireless device is registered at the controller
• Flashing: Error message from controller

Assignment of wireless devices

One wireless output sensor and up to seven wireless remote controls (7 zones are assigned) can be assigned to the receiver. The output sensor must be assigned to zone 0.

Assignment procedure

• To start the association mode, press the button of the wireless receiver until the red LED flashes (1 short pulse) and the green LED switches off.
• The receiver is now ready for the assignment of a device for zone 0 (wireless outdoor sensor). The assignment procedure for the outdoor sensor is described in the corresponding instructions (164591). After correct assignment, the green LED is ON, the red LED keeps flashing.
• To assign the next wireless device, press the button of the receiver again briefly. The red LED continues flashing, two short pulses indicate that the remote control for zone 1 can be assigned. If the number of short pulses is wrong, or the green LED is active, the button of the radio receiver must be pressed again. The assignment procedure for the wireless remote controls is described in the corresponding instructions (164586). After correct assignment, the green LED is ON, the red LED keeps flashing.
• This process has to be repeated for each remote control to be installed.
• After all devices are assigned, the assignment mode is finished by pressing the button on the receiver for 3 seconds. The red LED goes out, the green LED is lit.

CAUTION

• Assign only one device to each zone. Double assignments cause disturbances in operation.
• The number of pulses of the red LED on the receiver does not correspond to the zone number. This information is always one zone shifted (one pulse for zone 0, two pulses for zone 1, etc.).

NOTES

• All assignments are deleted by long pressing the button on the receiver (about 10s). The two LEDs will flash quickly.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Elesta RZM610A010 - Wireless Receiver Installation Instructions