Download Print this page

John Lewis EMILIA User Manual page 2

Touch lamp set of 2

Advertisement

Thank you for purchasing this
Introduction
EMILIA TOUCH LAMP SET OF 2
Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product.
The fitting is class II.
Warnings
This fitting should be fitted in accordance with IEE Regulations and the Building
Regulations. If in any doubt, or where required by law,
consult a competent person who is registered with an electrical self-certification
scheme. Further information is available online or from your Local Authority.
To prevent electric shock switch off at the mains supply before installing or
maintaining this fitting. Ensure other persons cannot restore the electricity supply
without your knowledge.
If you are in any doubt, please consult a qualified electrician.
If replacing an existing fitting, make a note of the connections.
Always use the correct type and wattage bulb. Never exceed the wattage
stated.When changing a bulb, always switch off at the mains and allow the old
bulb to cool down before handling. Dispose of used bulbs carefully.
The flexible cable of this product is not replaceable. If damaged, the product shall
be disposed of.
It is the installer's responsibility to ensure that the fixings and wall plugs used are
suitable for the surface you are fixing your product on.
CAUTION! The bulb and surrounding parts can become hot during use.
No.
Picture
list
Parts
A
B
01
Name
Qty
L199XW14 CRYSTAL CHAIN
X21
DIAMETER 93 STAINLESS
X1
STEEL SHEET
DIAMETER 13XH23CM LAMP
X1
BODY
Product assembly
1
2.
3
4
Step 1
Carefully unpack the carton, making sure
all parts are present before assembly.
Place lamp on a flat surface.
Step 2
Attach bulb(not included) to lamp holder
as indicated. The maximum power
indicated must not be exceeded.
Attach crystal chains o the frame as shown
in the diagram.
Step 3
Place disk diffuser on top of the table
lamp frame as indicated in the diagram.
Pay attention that the side with screw
downwards.
Step 4
Insert the plug into the power supply
and touch on the base to light on..
02

Advertisement

loading