Table of Contents
Advertisement
LC-26P55E
LC-26GA5E
LC-32P55E
LC-32GA5E
LC-37P55E
4. Check installation LPT driver using "C:\Program Files\Micronas\LptDrv\LptDrvTest.exe". After run this software, if
4. Check installation LPT driver using "C:\Program Files\Micronas\LptDrv\LptDrvTest.exe".
LPT driver is installed properly must appear this screen:
After run this software, if LPT driver is installed properly must appear this screen:
4. Check installation LPT driver using "C:\Program Files\Micronas\LptDrv\LptDrvTest.exe".
After run this software, if LPT driver is installed properly must appear this screen:
�� If the result is not OK, check inside PC bios: Parallel Port Mode=EPP
•If the result is not OK, check inside PC bios: Parallel Port Mode=EPP
To run VCTp software updater program, please click over "VCTP" icon from "START\All
programs\Micronas\Visual I2C\IC\VCTP" and after Visual I2C finish their starting process click on
To run VCTp software update program, please click over "VCTP" icon from "START\All programs\Micronas\Visual
I2C\IC\VCTP" and after Visual I2C finish their starting process click on "TVT" module. As additional method, it's pos-
�� If the result is not OK, check inside PC bios: Parallel Port Mode=EPP
"TVT" module. As additional method, it's possible to create a direct access to "C:\Program
sible to create a direct access to "C:\Program Files\Micronas\Visual I2C\ic\vct6wxyP\vctq_tvt.vi2c" and launch it from
Files\Micronas\Visual I2C\ic\vct6wxyP\vctq_tvt.vi2c" and launch it from Windows Desktop.
Windows Desktop.
To run VCTp software updater program, please click over "VCTP" icon from "START\All
programs\Micronas\Visual I2C\IC\VCTP" and after Visual I2C finish their starting process click on
"TVT" module. As additional method, it's possible to create a direct access to "C:\Program
Files\Micronas\Visual I2C\ic\vct6wxyP\vctq_tvt.vi2c" and launch it from Windows Desktop.
To start updating process follow next instructions:
1. Set Autoread in ON option.
2. Click on "GO" button.
3. Wait until "40" appears in Bootloader Version field.
4. Close DOS pop up windows pressing any key ("Press any key to continue...".).
5. Click on the "Erase flash" button and wait for a seconds and set the AutoRead to OFF.
6. Check in the desired software version is selected in the "Load BinàFlash" option. If it's not the correct one,
please double click on the file name and select it. The first time this software is use it's necessary to confirm write
Addressing margin as from 0x0 to 0x7ffff.
6
28
1
5
1
5
2
4
2
4
6
7
7
3
Advertisement
Table of Contents
