Cadillac CT4 2023 Owner's Manual page 33

32 Seats and Restraints
section. The memory recalls may be
cancelled at any time during the recall. See
Cancel Memory Seating Recalls later in this
section.
Identifying Driver Number
The vehicle identifies the current driver by
their remote key number 1 8. The current
remote key number may be identified by
Driver Information Center (DIC) welcome
message, You are driver x for memory
recalls. This message is displayed the first
few times the vehicle is turned on when a
different remote key is used. For Seat Entry
Memory to work properly, save positions to
the 1 or 2 memory button matching the
driver number of this welcome message. To
aid in identifying remote key IDs, it is
recommended to only carry one remote key
when entering the vehicle. Perform the
following if the welcome message is not
displayed:
1. Move all keys and remote keys away
from the vehicle.
2. Start the vehicle with another remote
key. A DIC welcome message should
display indicating the driver number of
the other remote key. Turn the vehicle
off and remove the other key or remote
key from the vehicle.
3. Start the vehicle with the initial key or
remote key. The DIC welcome message
should display the driver number of the
initial remote key.
Saving Seating Positions
Read these instructions completely before
saving memory positions.
To save preferred driving positions to
1 and 2:
1. Turn the vehicle on or to accessory
mode. A DIC welcome message may
indicate the driver number of the current
remote key. See Identifying Driver
Number previously in this section.
2. Adjust all available memory features to
the desired driving position.
3. Press and release SET; a beep will sound.
4. Immediately upon releasing SET, press
and hold memory button 1 or 2 matching
the current Driver s remote key number
until two beeps sound. If too much time
passes between releasing SET and
pressing 1 or 2, the two beeps will not
sound indicating memory position were
not saved. Repeat Steps 3 and 4 to try
again.
5. Repeat Steps 1 4 for the other remote
key 1 or 2 using the other 1 or 2 memory
button.
It is recommended to save the preferred
driving positions to both 1 and 2 if you are
the only driver.
To save the common exit seating position to
that is used by all drivers for Manually
Recalling Seating Positions and Auto Seat
Exit Memory Recall features, repeat Steps 1
4 using
, the exit button.
Manually Recalling Seating Positions
Press and hold 1, 2, or button until the
recall is complete, to recall the positions
previously saved to that button.
Manual Memory recall movement for 1, 2 or
buttons may be initiated and will
complete to the saved memory position if
the vehicle is in or out of P (Park).
If manual transmission equipped, Manual
Memory recall movement for 1, 2, or
buttons may be initiated and will complete
to the saved memory position if the vehicle
parking brake is set or released.