Contents 1 Preliminary note ���������������������������������������������������������������������������������������������������3 1�1 Notes on this document ���������������������������������������������������������������������������������3 1�2 Symbols used ������������������������������������������������������������������������������������������������3 1�3 Warning signs used ���������������������������������������������������������������������������������������3 2 Safety instructions �����������������������������������������������������������������������������������������������4 2�1 General ����������������������������������������������������������������������������������������������������������4 2�2 Installation and connection ����������������������������������������������������������������������������4 2�3 Tampering with the device �����������������������������������������������������������������������������4 3 Functions and features ����������������������������������������������������������������������������������������4 4 Installation������������������������������������������������������������������������������������������������������������5 4�1 Installation position of the device �������������������������������������������������������������������5 4�2 Place device onto the DIN rail �����������������������������������������������������������������������6...
1 Preliminary note 1.1 Notes on this document This document applies to devices of the type "power supply" (art� no�: AC1220 / AC1221)� It is part of the device and contains information about the correct handling of the product� This document is intended for qualified electricians� These specialists are people who are qualified by their training and their experience to see and to avoid pos- sible hazards that may be caused during operation of the device�...
2 Safety instructions 2.1 General ► Observe these operating instructions� ► Adhere to the warning notes on the product� Non-observance of the instructions, operation which is not in accordance with use as prescribed below, wrong installation or incorrect handling can affect the safety of operators and machinery�...
4 Installation 4.1 Installation position of the device 1: DC output voltage top 2: AC input voltage bottom 3: Convection cooling A: A = 30 mm (free space for convection cooling) ► Install the DIN rail for receiving the device horizontally�...
4.2 Place device onto the DIN rail 1� Angle the device and hook it onto the upper edge of the DIN rail� 2� Push the device downwards and press to lock� > The device audibly clips into place� 4.3 Remove the device 1�...
5 Electrical connection WARNING Dangerous contact voltages� Electric shock possible in the case of contact� ► Disconnect the system from power before working with it� ► Protect the system against unintentional switch-on� ► Select the correct connection cables for the load and the environmental conditions�...
5.2 Core cross sections Type of wire Max� core cross-section massive 1�5 mm² flexible 1�5 mm² (with wire end ferrule) − For Industrial Control Equipment in North America: Use copper conductors with min� cross-section AWG16 (1�5 mm 5.3 External fuse ►...
► Do not touch the device during operation or immediately after it has been switched off� 8 Technical data 8.1 Data sheets Data sheets can be found at: www.ifm.com → Data sheet direct: → AC1220 / AC1221 9 Maintenance, repair and disposal The device is maintenance-free and does not contain any components that need to be maintained by the user� WARNING Tampering with the device can affect the safety of operators and machinery�...
Page 10
The EC declaration of conformity and approvals can be found at: www.ifm.com → Data sheet direct: → AC1220 / AC1221 → Approvals...