Chloride F100 Installation And Operating Instructions Manual

F100 Industrial Duty Emergency Unit
Installation and Operating Instructions
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
All servicing should be performed by qualified personnel only.
•
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended use.
•
Do not use outdoors.
•
• Do not let supply cords touch hot surfaces.
• Do not mount near gas or electric heaters.
Do not mount near open flames or sparks.
•
•
The battery supplied with this equipment is a sealed maintenance free lead calcium battery. Do not attempt to
service this battery.
SAVE THESE INSTRUCTIONS
CAUTION: To avoid electrical overload, total connected lamp load (factory and field installed) should not
exceed output rating.
WARNING – Shut off AC power to branch circuits to which units will be connected. All wiring should be per
N.E.C. Articles 501-4(b) and local codes.
To maintain warranty, equipment with batteries must be installed or placed on charge within prescribed period
after shipment.
Signify North America Corporation
400 Crossing Blvd, Suite 600
Bridgewater, NJ 08807, USA
Phone: 855-486-2216
www.chloride-lighting.com
(With IntelliCharge)
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Phone: 800-668-9008
443580516562
July 2022