Page 1
The type and quantity of components may vary for different style sheds. Assembly of all shed styles is by the same method as detailed. Before assembling the shed, please check that all parts are present. Report any shortages or other issues immediately. DO NOT attempt to modify the shed or any of it's parts as this may invalidate the warranty.
Page 2
The floor and floor bearers are supplied separately. The ROOF is supplied with batons attached. If your shed has two or more floor boards, please follow one of the following methods shown in the diagram below. The floor bearers will be either the same length as the width or the depth of the floor. Place each floor bearer approx.
Page 3
Step.4 Step.1 Position the front and rear apex panels on to the top of the front and rear panels. Fix the apex panels in place using the Lay two of the large roof boards onto the shed as shown. Using the 40mm screws, fix the roof brace into position by 60mm screws as shown above.
Page 4
If the shed has more than tow lengths of felt, position the first length along the lower edge on one side of the roof and fix as shown. Repeat on the other side of the shed. Place the final piece of the felt over the apex of the roof, ensuring To fit the windows it is recommended that a waterproof sealant is applied around the edge of the glazing before fitting.
This manual is also suitable for:
Premier apex 9000Premier apex 9200Premier apex 9800Premier apex 1000050606595350205060659534863...
Show all