AXAGO EE25-XP - Mobile USB Hard Drive Case Quick Installation Guide

Table of Contents

Contents

1 MOUNTING THE HARD DRIVE
2 HARD DRIVE ASSEMBLY
3 CONNECTION
4 INFO
5 DISCONNECTION
6 DATA BACKUP
7 TECHNICAL SUPPORT
8 Documents / Resources
- 8.1 Download manual

MOUNTING THE HARD DRIVE

MOUNTING THE HARD DRIVE - Step 1

FIGURE 6: Windows application Cabinet for data backup

Lightweight plastic external box with USB interface intended for 2.5" SATA drives. In external box there is a fixed attached flexible USB cable that enables direct connection to notebook without any need for another cable. The case can be very fast opened without undoing any screws. The One Touch Backup feature also makes the external drive an easy-to-use backup device.

HARD DRIVE ASSEMBLY

Open the lock on the back of the box cover (Fig. 1).
Then remove the back cover by pulling lightly in the direction of the arrow (Fig. 2).
Insert the hard drive into the SATA connector on the motherboard of the box (Fig. 3).
Install the front cover again and close back cover by pulling lightly in the direction of the arrow (Fig. 4).
Close the lock on the back of the box cover (Fig. 5).

CONNECTION

Connect the case to the computer with the USB cable supplied; you can do it also while your PC is running.
The case with disk is detected and installed automatically.
Check the correct installation in Device Manager (Fig. 7).
Initialize the new disk and format it in Disk Management (Fig. 8).

FIGURE 7: Using Device Manager to check whether the installation is correct in Windows 7 (only devices which are added to the Device Manager when installing the case and the hard drive are displayed)

FIGURE 8: Initialization of the disk in Disk Management

INFO

When connecting via USB cable, the hard drive is always detected automatically (Plug & Play).
If the hard drive is detected in the Device Manager but is not displayed in the My Computer folder, check its allocation in Disk Manager.
The box has two LED indicators. The green LED indicates the connection of the box and the flashing red LED indicates the process of data transmission.

DISCONNECTION

If you want to disconnect the case with disc, make sure that data copying has been finished and that the data transmission indicator (red LED) is not flashing. Then you can disconnect the case.
However, the safest method for removing from the computer is the utilization of Safely Remove Hardware function in Windows operation system (Fig. 9). We recommend you to use this method as well.

FIGURE 9: Using the Safely Remove Hardware function in Windows 7

DATA BACKUP

To use backup feature by OTB button, backup software must be installed.
On the CD supplied in the directory: EE25-XP\Backup\ launch the file Cabinet.exe and install the application Cabinet for data backup (Fig. 6).

TECHNICAL SUPPORT

In the case that you have a technical problem with your device, you need more information or technical advice, you do not have any drivers, etc., visit first web pages AXAGO at www.axago.eu.
If you do not find a satisfactory answer, you can contact our technical support. For technical issues, use the address: support@axago.cz.

© 2010 AXAGO Czech Republic
All rights reserved. All text and pictorial materials contained in this document are protected by Copyright Act. All marks indicated here are the registered trademarks of their appropriate owners.
Specifications are subject to change without prior notice.