Table of Contents A Message from the Corporate Office ..........1 Safety Instructions .................2 Identifying Features ...............3 Use as an Air Purification System ..........4 Vacuuming Instructions ..............5 Vacuuming Tips ................6 Steam Cleaning Instructions-Set up..........7 Steam Cleaning Operational Instructions ........8 Steam Cleaning Tips ..............9 Picking Up Liquids/Wet Pickup ..........10 Carpet Maintenance Program ............11 Secondary Filtration System, Instructions &...
500,000 units sold worldwide. You have seen many of our commercial machines for rent in grocery and hardware stores across the country. We have adopted our own brand name, Thermax, which is rapidly becoming a household name, synonymous with the industry.
Important Safety Instructions Read before operating this system. WARNING To Reduce The RIsk of fIRe, elecTRIc shock oR INjuRy: 1. Always disconnect the canister and optional steam cleaning solution tank accessory from the power source BEFORE servicing. 2. Never leave the appliance plugged into power source unattended. 3.
23. Crevice Tool The OPTIONAL STeAM CLeANING ACCeSSORY KIT (32-030-121) does not come standard with your AF2. Contact your local Distributor or the corporate office to receive details on purchasing or receiving it free through our referral program (see page 17 for other accessories that complete this kit): 1.
The Thermax AF2 is now washing the air of impurities. Run for approximately ten (10) minutes per room, or 1 hour centrally located in your home, preferably by the central A/C intake. Run your AF2 this way about twice a week, depending on the severity of your allergies.
Vacuuming Instructions 1. Fill Water Filtration Recovery Tank to the fill line as noted on the label and make sure the filter tube, filter chamber & baffle shut off assembly are all in place. 2. Add Aqua Blue or fragrance to water as indicated on its label if desired. 3.
VACuuMING INSTRuCTIONS CONTINued… 11. Pull out the main power cord and plug into electrical outlet. The cord will stop at any location you desire when pulling it out. To retract, depress the cord reel actuator and cord will start to retract. Hold the power cord by the plug when retracting into the canister.
3. Replace recovery tank, close and latch front lid. 4. Remove twist cap from the Steam Cleaning Solution Tank. Add two ounces of Thermax Liquid Carpet & Upholstery Cleaner and then fill with hot tap water. Replace the cap and shake the solution tank to thoroughly mix the cleaner.
STEAM clEANINg INSTRUcTIoNS-SET UP coNTINUED 9. Snap trigger valve bracket onto handle as shown. 10. Connect the hose from the steam head into the spray valve. 11. Connect the end of the trigger solution hose into the solution tank fitting. Steam Cleaning Operational Instructions 1.
To prevent overflow, your AF2 employs an automatic flotation ball shut-off system. Always be sure that the flotation ball is in its holder when operating your AF2. For more information or to place an order call 1-888-764-3700...
4. Attach electrified vac hose (EVH) into hose lock (page 5 #5). NoTe: DO NOT insert the male plug end of the EVH cord into the auxiliary outlet when operating your AF2 as a wet pickup vacuum. 5. If attached, remove motorized vacuum head and power cord from sliding wand and replace with the spray and recovery head, hard floor tool, any on board tool, or optional squeegee.
This is where the hot water extraction (steam cleaning) function of the Thermax AF2 is needed. The AF2 has this capability. (If yours is not so equipped, contact your local distributor for information.) Hot water extraction is a flushing action of hot water and cleaning solutions sprayed into the carpet fibers or upholstery.
Triple Filtration The Thermax AF2 has a unique triple filtration system. The water in your Water Filtration Recovery Tank is the primary filter. It strips away the dirt and all particles that the water can saturate. As the air leaves the tank, it travels through a second filter in the tank lid.
4 weeks between replacement. • The “dirt” you see on the surface of the AF2 filter represents millions of non water soluable and microscopic sized particulates that would normally escape undetected into the surrounding environment with any other standard type vacuum.
Parts Diagrams Canister Only 1. Front Lid Assembly Complete 24-105-000 2. Hose Lock Assembly 37-025-000 3. Rear Lid Assembly 24-050-001 4. Crevice Tool 01-242-01 5. Hinge Kit with Screws 32-905-000 6. Latch Kit with Screws 32-902-000 7. Upholstery Tool with slide on brush 35-300-000 8.
Hard Floor Tool MAINTENANCE/CLEANING INSTRUCTIONS: Remove Debris in neck of tool and brush as required. 1. Hard Floor Tool 10" 35-310-001 Telescopic Stainless Steel wand MAINTENANCE/CLEANING INSTRUCTIONS: Periodically flush with hot water to remove dust and debris. 1. Sliding Wand 32-075-000 Electrified Vacuum Hose Assembly (120V)*...
2. Deluxe Hard Floor Tool 35-515-000 The Deluxe Floor Tool is to complement the cleaning ability of the AF2 on bare floors. There is an optional pad which attaches to the bottom of this tool to help safeguard hard wood floors.
These miniature water based air fresheners work off the same within its fibers. Often times, this foreign matter concept as the AF2. The Minimax uses the same deodorizers has a tendency to excessively foam when & aromatizers listed above. The large model is designed to...
Great rental machines for any retail store • Auto detailing • Commercially cleaning carpets in your area. cP- THERMINAToR THERMAX cP THERMINAToR cP1-DV The Thermax “Therminator” Cleaning The Thermax CP5 is an industry proven The Therminator CP12-DV is Thermax’s System offers features no other cleaning performer, built to endure the most newest industrial steam cleaner, which system can.
Trouble Shooting Tips coNDITIoN AND cAUSE coRREcTIoN Vac Motor Won’t Run 1. Canister not plugged into outlet ........... Plug canister into working outlet 2. Defective vacuum switch .............. *Replace vacuum switch 3. Loose terminal connections ............*Check ALL terminal connections 4.
Specifications When calling in for service, ordering accessories or spare parts, it’s important to know the Model Number and Serial Number of your canister. The Model Number and six-digit Serial Number will appear on a white label located under the rear lid. If this is missing or defaced, please call the factory immediately as it may have an impact on your warranty.
10 Year replacement Part warranty Manufacturer will replace or repair, at its option, parts for the AF2 system, if found to be defective in material or workmanship, for a period of 10 years from the date of purchase. This Limited Warranty is only extended to the original purchaser, and the system must be used in accordance with the Operations Manual and is non transferable.
Need help?
Do you have a question about the AF2 and is the answer not in the manual?
Questions and answers