Table of Contents
Advertisement
6.- Pieces and services.
To order spare parts or for any technical repairs to this product, contact your distributor, Ferno.
They are the only agent authorised by Ferno to manage and repair Ferno products.
ATTENTION
Spare parts and services that are not in accordance with Ferno specifications may cause
injury. Only use original Ferno parts for this fastener.
7. Installing the fastener.
7.1. Installation.
Installation of the fastener requires the competence of a professional who develops ambulances.
ATTENTION
The fastener was created to be installed with a steel backing sheet with a minimum
measurement of at least 6.4 mm, under the installed surface (bottom of ambulance, floating
table or tray).
If the vehicle in which you install the fastener does not have the backing sheet that is
required, it must be installed by a qualified professional.
7.2. Vehicle.
If you assemble the fastener on the floor of an ambulance, check the side under the ambulance to
avoid oxygen leaks into the petrol tank and into any other installation.
Always install a new fastener when an ambulance is equipped.
7.3. Included pieces
The total fastener set including the front part and back part linked together.
The logo "Push" must be placed in front of the unlocking handle of the F1 fastener
7.4. Scheme.
Serial Number
Advertisement
Table of Contents
