Follow the below steps:
1. Loosen the hand-wheel and then remove the vacuum snout.
2. Insert bump of the connecting seat into the U Groove and then
tighten the hand-wheel, as illustrated in the diagram below.
3. Attach the Blowing Hose to the ventilation pipe using the clamp,
pass the screw of the connecting weldment through the hole in the
frame tube and then tighten the nut according to the required blow
angle. Illustration is as follows:
___________________________________________________________________________________
Operation Manual RedGum Garden Vacuum
CHANGING THE VACUUM HOSE
Page 8
RGVAC-0323 Rev 2