Care And Cleaning - AEG DVE5671HG User Manual

5.2 Hob²Hood function
It is an automatic function which connects the
hob with a hood. Both the hob and the hood
have an infrared signal communicator. Speed
of the fan is defined automatically on basis of
mode setting and temperature of the hottest
cookware on the hob. You can also operate
the fan using the hob manually. The function
can be activated from panel of the hob.
For more information how to use the
function refer to the hob user manual.
5.3 Activating Maximum Motor
Speed
When you touch
Speed starts to operate for 8 minutes. After
that time, the appliance returns to its previous
speed settings.
When the function is turned on, additional
touch on does not have any effects.
5.4 Filter notification
Filter alarm reminds to change or clean the
charcoal filter and clean the grease filter. The

6. CARE AND CLEANING

6.1 Notes on cleaning
Cleaning Agents
Keep the hood
clean
, the Maximum Motor
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains appliance must be
cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the interior and grease filters
carefully from fat. Fat accumulation or other residue may cause fire.
Follow the instructions for cleaning the accessories when filter notification is on. Refer to
Filter notification in daily use chapter.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may
discolour, it has no influence on the performance of the appliance.
filter indicator
seconds if the grease filter must be cleaned.
The filter indicator
seconds if the charcoal filter must be
replaced or cleaned.
Refer to cleaning the grease filter in care
and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To reset the function touch
To activate or deactivate function:
1. Switch on the control panel.
2. Make sure that the icons are turned
white.
3. To activate function touch
seconds.
If the function is activated, the filter icon
flashes (red) five times.
4. To deactivate function touch
seconds.
If the function is deactivated, the filter icon
flashes (red) three times.
59
is turned on (red) for 30
flashes (red) for 30
for 3 seconds.
for 3
for 3