Prime TNOLED02 - Light Sensing Digital Countdown Timer Step-by-step Instructions

STEP-BY-STEP INSTRUCTIONS

1. INSTALL TIMER to a vertical a flat surface close to a properly installed outdoor-rated grounded receptacle
   
   1. Using a screw or hook (not included), secure the MOUNTING TAB at the top of the timer to a wall or post.
   2. For a more secure mounting, use the two MOUNTING HOLES on the back of the timer.
      • Create a mounting template by placing a sheet of paper over the back of the timer and punching holes through the paper where the mounting holes are located on the timer.
      • Temporarily secure the mounting template to the flat surface where the timer is to be mounted.
      • Drill two 3/32 inch pilot holes where indicated on the mounting template.
      • Insert two #6 sheet metal screws (not included), leaving screw heads protruding 1/8 inch from the surface.
      • Place the timer over the screw heads and push down to lock into place.
2. Plug timer into an ELECTRICAL OUTLET
   Use an outdoor-rated three-pronged grounded electrical outlet. Do not use extension cords to connect the timer to the power source.
   
3. Set the desired "OPERATING MODE"
   Press the "SET" button to cycle the LED's to the desired mode. After 5 seconds, LED will flash rapidly to confirm selection.
   
   ON - Power is on to attached devices
   2 Hrs - Power will turn on at dusk and remain on for 2 hours
   4 Hrs - Power will turn on at dusk and remain on for 4 hours
   6 Hrs - Power will turn on at dusk and remain on for 6 hours
   8 Hrs - Power will turn on at dusk and remain on for 8 hours
   12 Hrs - Power will turn on at dusk and remain on for 12 hours
   Dusk-Dawn - Power will turn on at dusk and remain on until dawn
   OFF - Power is off to attached devices
4. Attach up to TWO DEVICES to the timer
   Plug the devices into the outlets on the bottom of the timer.
   

HELPFUL TIPS

• This timer is weather-resistant and rated for Outdoor Use. The timer will function outdoors when installed and operated as outlined in this manual.
• This timer operates using a light-sensitive photocell that senses when the environment is getting dark (dusk) or light (dawn). The photocell is located above the "SET" button on the face of the timer.
• Once programming activates at dusk in the 2hr, 4hr, 6hr, 8hr, 12hr or dusk-to-dawn mode, the program cycle will complete before the timer resets. Headlights, porch lights, street lamps and other external lighting sources will not interfere with the active timer program.
• When set to "ON", the timer will provide continual power to attached devices until the timer is switched to "OFF", or to any of the other Operating Modes.
• The LED next to the programmed mode will glow red when the timer programming is activated and power is being provided to attached devices.
• To view the program that is currently set when the timer is not providing power to the attached devices, press the "SET" button. The LED next to the programmed mode will illuminate.