Summary of Contents for Ruwac DV460 Series
- Page 1 USA Industrial Vacuums DV460 Series Installation, Operation, Maintenance & Service Model No. Serial No. Filter No. Start-Up Date Version: 1.0 11/04/21 54 Winter St. • Holyoke, MA 01040 • (413) 532-4030 • info@ruwac.com...
-
Page 2: Table Of Contents
Table of Contents Contents Page Warranty Safety III. Start-Up Inspection and Maintenance Trouble Shooting VI. Terms and Conditions Questions? Call Ruwac USA at (413) 532-4030 or e-mail us at info@ruwac.com! -
Page 3: Warranty
RUWAC service personnel are covered by a 120-day parts only warranty. RUWAC, Inc. will not assume any responsibility under the terms of this limited warranty on equipment, which has not been paid in full. This warranty does not apply to any equipment that has been disassembled, repaired, or otherwise altered by any person without the written authorization of RUWAC’S service department, nor does it apply to any product that has... -
Page 4: Safety
Safety CAUTION: Ruwac DV460 series machines are not to be used for the removal of liquids or any volatile, viscous, flammable or explosive media. If you are unsure about your application requirements consult your Ruwac representative. CAUTION: Ruwac DV460 series machines are designed for continuous use, provided the vacuum is not held under constant stress. - Page 5 Note: If continuity is not found across any of these points, consult the parts manual to check that all ground wires are in place. For further assistance, contact Ruwac.
-
Page 6: Start-Up
This will The dustpan should ensure that excess be emptied after ever material sticks to the use. filter. Questions? Call Ruwac USA at (413) 532-4030 or e-mail us at info@ruwac.com! -
Page 7: Inspection And Maintenance
Note: Using an object to dislodge material may tear the filter. Consult your RUWAC representative if material blockage is excessive. Do not use high pressure compressed air or water to clean off filter, as material may become permanently lodged into filter membrane. - Page 8 NOTE: The presence of material in this area or in the exhaust is often the result of a misaligned seal or damaged filter. Consult your RUWAC representative if either is the case. Questions? Call Ruwac USA at (413) 532-4030 or e-mail us at info@ruwac.com!
- Page 9 Inspection & Maintenance DV460 SERIES STANDARD INSTRUCTIONS: FILTER INSTALLATION CAUTION: Motor deck will be heavy and will require a hoist to remove. Always wear a dust mask when performing filter inspections or service. Reinsert black mesh Insert the filter cage...
- Page 10 Remove and replace Tighten the bracket Replace the With the motor running the HEPA filter. hardware. motor deck, attach and inlet blocked, the ground wire. secure the motor deck hardware. Questions? Call Ruwac USA at (413) 532-4030 or e-mail us at info@ruwac.com!
- Page 11 Inspection & Maintenance DV460 SERIES STANDARD INSTRUCTIONS: HEPA MAXX FILTER FIELD INSTALLATION CAUTION: Motor deck will be heavy and will require a hoist or two users to to place atop work bench or table. Remove the motor Remove the motor...
- Page 12 2 locations point out above. above. Block the inlet and turn Insert ¼-20 bolts with Competed unit as on the vacuum. lock washers into the shown. 6 locations pointed out above. Questions? Call Ruwac USA at (413) 532-4030 or e-mail us at info@ruwac.com!
-
Page 13: Troubleshooting
- Belt worn, cracked, damaged, - Follow belt / turbine / motor inspection in previous stretched, loose pages Vacuum Motor Shuts - Confirm the amperage setting Down Prematurely on motor overload Questions? Call Ruwac USA at (413) 532-4030 or e-mail us at info@ruwac.com! -
Page 14: Terms And Conditions
Buyer shall set aside and hold rejected goods without further processing until RUWAC has an opportunity to inspect and advise of the disposition, if any, to be made of such goods. In no event shall... - Page 15 LIMITED WARRANTY: RUWAC warrants that new equipment which are complete units and are sold and/or manufactured by RUWAC, Inc. will be free from defects in material and workmanship for a period of 18 months from date of shipment or 12 months from date of start-up, whichever comes first. RUWAC warrants that replacement parts sold hereunder will be free from defects in material and workmanship for a period of 120-days after the date of shipment.
- Page 16 RUWAC. RUWAC’S failure to strictly enforce any right on one occasion does not constitute a waiver of that or any on any other...
Need help?
Do you have a question about the DV460 Series and is the answer not in the manual?
Questions and answers