Sharp LC-32WD1RU Service Manual page 18

LC-32WD1E/S/RU and LC-32WT1E
[7] SERVICE MENU SETTINGS
CAUTION:
Only the items described in this section should be modified. Do not modify any other settings available in
the service menus.
Item # Item
000 GTV
Application
001 Init TV
276 Gam-20IRE-R
277 Gam-80IRE-R
278 Gam-20IRE-G
279 Gam-80IRE-G
280 Gam-20IRE-B
281 Gam-80IRE-B
858 Virgin bit
925 Last Error
Code
926 Error Count
927 LCD Size
[7.1] Using Init TV
CAUTION:
When factory settings have been made, all user setting data, including the channel settings, are initialized.
(The adjustments done in the adjustment process mode are not initialized.) Keep this in mind when
initializing these settings.
Item # Item
001 Init TV
Available
Settings Remarks (adjustment details, etc.)
Not Applicable 1st line describes the overall SW package version name (See [6.2].)
2nd line describes the UOC/GTV SW version
3rd line on the right describes the PNX SW version
0 = Off Initialization to factory settings. When the factory settings have been made, all
user setting data, including the channel settings, are initialized. (The
= Activate
adjustments done in the adjustment process mode are not initialized.)
See "Using Init TV" on page 5-7.
0 - 255 White Point Calibration. See "Using White Point Calibration Items" on page 5-8.
0 - 255 White Point Calibration. See "Using White Point Calibration Items" on page 5-8.
0 - 255 White Point Calibration. See "Using White Point Calibration Items" on page 5-8.
0 - 255 White Point Calibration. See "Using White Point Calibration Items" on page 5-8.
0 - 255 White Point Calibration. See "Using White Point Calibration Items" on page 5-8.
0 - 255 White Point Calibration. See "Using White Point Calibration Items" on page 5-8.
0 = Off Puts the TV into virgin mode. When the TV is restarted, the TV will start in virgin
mode. The Auto Install menu (wizard) will start when the TV is restarted, but the
1 = On
EEPROM settings are not erased. See "Using Virgin Bit" on page 5-9.
Not Applicable The last error code recorded.
0x00 = DTV HANGUP
0x01 = POWER_ON_RESET
0x02 = SUPPLY_VOLTAGE_INDICATION_ERROR
0x04 = OUTPUT_VERTICAL_GUARD_ERROR
0x08 = XRAY_PROTECTION_ERROR
0x10 = PROTECTION_1_8V_SUPPLY_VOLTAGE_ERROR
Not Applicable Number of times the set went into reset due to an error.
1 = LC-32WD1E Sets the panel size of the TV. Set this setting after replacing the mainboard. This
setting must be set to make sure the right settings are loaded for this TV
1 = LC-32WT1E
(gamma table, etc.).
2 = LC-32WD1S
3 = LC-32WD1RU
Adjustment Conditions
See caution above.
Adjustment Procedure
1. Enter the adjustment process mode.
2. Go to this item. Press
The screen will go dark and the LEDs on the front of the TV
will alternate between cycling and all illuminated.
When finished, the On/Standby LED will illuminate GREEN
and the TV will be on.
CAUTION: Never turn the power off during initialization.
5 - 7
.