Snakebyte WIRELESS PRO-CONTROLLER SB913716 for Nintendo Switch Manual

Table of Contents

Contents

1 Overview
2 PAIRING
3 LOADING CONTROLLER
4 RECONNECTING PAIRED CONTROLLER
5 TECHNICAL SPECIFICATIONS
6 TURBO FEATURE
7 INFORMATION
8 SAFETY PRECAUTIONS
9 HEALTH PRECAUTIONS
10 CUSTOMER SUPPORT / TECHNICAL SUPPORT
11 Documents / Resources
- 11.1 References
- 11.2 Download manual

Overview

Overview - Front View
Overview - Rear View

Direction Pad
Action Buttons
Left Analog stick(L)
Right Analog stick(R)
HOME button(Power on/off)
LED indicator
Turbo button
Capture button
Menu selection -
Menu selection +
L/ZL Buttons
R/ZR Buttons
Power off / Reset

PAIRING

Enter System Settings on the Home Screen of the Console.
Select Change Grip/Order under Controllers and Sensors.
Press and hold Home on WIRELESS PRO-CONTROLLER. for approximately 5 seconds, until the red LED's starts flashing fast.
Wait for the Gamepad-Icon to show up under the connected controllers (this may take up to 10 seconds). The red LED will be illuminated to indicate that connection has been established.
Press A to finish pairing procedure.
To use vibration control combination buttons, you should turn on the vibration setting in the console, then simultaneously press "L3" & "-" to turn on or turn off the vibration function.

LOADING CONTROLLER

The controller comes with micro USB charging cable. To charge the controller, connect the micro USB connector to the controller, and the USB connector to the console.
The battery is not replaceable.

RECONNECTING PAIRED CONTROLLER

Press Home on WIRELESS PRO-CONTROLLER at anytime, when the Console is switched on.
An illuminated LED indicates that the connection has been established.

Please note that, while the Console can be put to Sleep Mode using WIRELESS PRO-CONTROLLER, it cannot be woken up with it and needs to be switched on manually using its POWER-Button.

TECHNICAL SPECIFICATIONS

Model number:	SB913716	Frequency:	Bluetooth™
Input Power:	DC 5V / 330mAh	Output Power:	DC 3.7V / 20mAh
Battery capacity:	500mAh	Battery type:	3.7V/Polymer Li-ion
Working Range:	8-10m

TURBO FEATURE

Press & hold any button you want to program it as turbo feature.
Press Turbo button to active turbo feature for the button you hold at step 1.
You can program all buttons in turbo feature except ZR & ZL.

Press & hold the programmed button then press turbo button again to cancel the turbo feature.

INFORMATION

If you experience functional issues using WIRELESS PRO-CONTROLLER, please download the latest firmware installer from www.mysnakebyte.com, then run the installer program and follow the on screen instructions.

SAFETY PRECAUTIONS

Do not expose the product to extremely hot, or cold temperatures, high humidity or direct sunlight.
Do not use the product close to any heat sources.
Do not subject the product to any liquids and never use it when the product is wet
Do not put heavy objects on the product.
Do not throw or drop the product.
Do not attempt to take apart, open, service or modify the product. Doing so could present the risk of electronic shock, damage, fire, or other hazard.
Clean only with a soft, dry cloth. Avoid cleaning solutions, solvents or other chemicals and do not attempt to clean connectors as this may damage the product.

HEALTH PRECAUTIONS

If you feel tired, experience any discomfort or pain in your arms, or hands, stop using the product immediately and consult a doctor, if the conditions persist.
Avoid prolonged use of this product and take a break about every 30 minutes.