They are also marked in Elementvägen 15 - SE-702 27 Örebro - Sweden accordance with the WEEE-directive 2012/19/EC. Tel: +46 19 20 67 65 - E-mail: info@dls.se The products are also produced in accordance www.dls.se with the EU RoHS directive 2015/863/EU.
Pre installation Included products: Disconnect Battery 1pc Subwoofer Before you start the pro- cess of replacing subwoofers, disconnect and secure the Included in box: negative terminal from your battery/power source. 1pc PRY tool This will prevent the risk 1pc Manual of damaging yourself or the products.
Installation Dismounting seat HINT: There are electric connections under the seat. These need to be connected during the operation otherwise there is a huge risk that an airbag or other warning lamp lights up. 1) On some newer models, there can be a plastic cover on the seat frame. This plastic can be a bit tricky to remove.
Sometimes it’s easier to lift up the subwoofer, before unplugging the connector. There is a gasket under the subwoofer, remove this. On older models, the gasket can be stuck on the subwoofer housing. Make sure to remove all of it. The new DLS subwoofer has a new gasket.
Plug the OEM connector in the DLS subwoofer. Mount the subwoofer in the housing. There is a dowel pin by the connector for lining up the subwoofer. Make sure the connector is still fixed.
Specifications DLS Cruise CRPP-BMW1.8 Subwoofer Technical Specification Electro-Acoustic Parameters Size 8” / 200 mm 3.3 Ohm RMS Power 120 W 45 Hz MAX Power 240 W 43.5 gr Voice Coil Size 2” / 50 mm 0.28 Voice Coil Material CCAW voice coil / Kapton former 22.63 L...
European Economic Area (EEA). DLS products complies with the relevant provisions of the RoHS Directive for the European Union. In common with all Electrical and Electronic Equipment (EEE) the product should not be disposed of as household waste.